User manual WHIRLPOOL WRT348FMEW USE & CARE GUIDE

[. . . ] REFRIGERATOR USER INSTRUCTIONS THANK YOU for purchasing this high-quality product. For future reference, please make a note of your product model and serial numbers. These can be located on the inside wall of the refrigerator compartment. 35 W10795669A REFRIGERATOR SAFETY Your safety and the safety of others are very important. [. . . ] It will also reduce the amount of time the refrigerator door is open, and save energy. Slide the shelf straight out to the stop. Depending on your model, lift back or front of the shelf past the stop. Replace the shelf by sliding the back of the shelf into the track in the wall of the cabinet. Guide the front of the shelf into the shelf track. Be sure to slide the shelf in all the way. NOTE: Turn the ice maker off before removing the ice storage bin to serve ice or to clean the bin. This will keep the ice cubes from dropping out of the ice maker and into the freezer compartment. After replacing the ice storage bin, turn on the ice maker. Ice Production Rate NORMAL Ice Production: The ice maker should produce approximately 8 to 12 batches of ice in a 24-hour period. If ice is not being made fast enough, turn the Freezer control toward a higher (colder) number in half number steps. (For example, if the control is at 3, move it to between 3 and 4. ) Wait 24 hours and, if necessary, gradually turn the Freezer Control to the highest setting, waiting 24 hours between each increase. MAXIMUM Ice Production (on some models): The ice maker should produce approximately 16 to 20 batches of ice in a 24-hour period. If your refrigerator has the maximum ice production feature, push the switch to MAX. Remember Allow 24 hours to produce the first batch of ice. Allow 3 days to completely fill the ice storage bin. Discard the first three batches of ice produced. The quality of your ice will be only as good as the quality of the water supplied to your ice maker. avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained. [. . . ] Service to correct improper product maintenance or installation, installation not in accordance with electrical or plumbing codes or correction of household electrical or plumbing (i. Defects or damage caused by the use of non-genuine Whirlpool parts or accessories. Damage from accident, misuse, abuse, fire, floods, acts of God or use with products not approved by Whirlpool. Repairs to parts or systems to correct product damage or defects caused by unauthorized service, alteration or modification of the appliance. [. . . ]