User manual WHIRLPOOL WRX988SIBH ENERGY GUIDE

[. . . ] This manual was printed on recycled paper. Keep it for future reference. MDT5N25 & WRX988SIBH FOR THE INSTALLER: Specifications This ice maker-dispenser is designed to be mounted on a machine stand, or a countertop, or using wall mounting kit KWB3, hung from a wall. The sink may be retained, or removed and the optional longer splash panel (KSP5) installed in place of the original. Instructions for each kit are included in this service manual. [. . . ] Remove the cover to the water reservoir and block the float up. Drain the water reservoir and freezer assembly using the drain tube attached to the freezer water inlet. Return the drain tube to its normal upright position and replace the end cap. Prepare the cleaning solution: Mix eight ounces of Scotsman Ice Machine Cleaner with three quarts of hot water. The water should be between 90-115 degrees F. Scotsman Ice Machine Cleaner contains acids. In case of external contact, flush with water. As the ice maker begins to use water from the reservoir, continue to add more cleaning solution to maintain a full reservoir. After all of the cleaning solution has been added to the reservoir, and the reservoir is nearly empty, switch the master switch to OFF. After draining the reservoir, as in step 6, wash and rinse the water reservoir. To Sanitize: Repeat steps 8-11, only use an approved sanitizing solution in place of the cleaning solution. Disconnect electrical power to the icemaker dispenser before beginning. Note: Water filters can filter out suspended solids, but not dissolved solids. "Soft" water may not be the complete answer. Check with a water treatment specialist regarding water treatment. For more information on removal of these parts, see REMOVAL AND REPLACEMENT. To remove the auger, remove the front and top panels. Push bail clamp off of cover and remove cover. Remove 4 allen screws holding breaker to evaporator. After the auger has been removed, allow the auger to dry: if the auger is not bright and shiny, it must be cleaned. Clean the auger and evaporator as required. Reverse to reassemble. May 2001 Page 20 SERVICE DIAGNOSIS Symptom No ice made, nothing operates Possible Cause Unit off due to no power MDT5N25 & WRX988SIBH Probable Correction Restore power Switch master switch to ON Check water supply, filter, strainer, float valve. [. . . ] Scotsman also recommends that, at the time of initial start up, gauges not be used. ·If gauges must be used, use very short hoses to ·Refrigerant should not be added except as a minimize refrigerant discharged into the air. way to determine the proper operation of the product. If the system was low on refrigerant, there is a leak, and it must be found and repaired. high side pressure. If the condenser is clean and seems to be operating correctly, it most likely is. [. . . ]