User manual WHIRLPOOL WSC5553AN

[. . . ] INSTALLATION BEFORE INSTALLING THE REFRIGERATOR WATER CONNECTION ELECTRICAL CONNECTION LEVELLING YOUR REFRIGERATOR REMOVING THE FREEZER DOOR (A) REMOVING THE REFRIGERATOR DOOR (B) MOUNTING THE FREEZER DOOR (C) MOUNTING THE REFRIGERATOR DOOR (D) HORIZONTAL ALIGNMENT OF FREEZER AND REFRIGERATOR DOORS (E) VERTICAL ALIGNMENT OF FREEZER AND REFRIGERATOR DOORS (F) 3 BEFORE INSTALLING THE REFRIGERATOR Your new appliance is a FULL NO FROST model exclusively for domestic use, i. e. both refrigerator and freezer compartments are provided with an automatic defrosting function. [. . . ] · Make sure that the water tube is not twisted. · The appliance is pre-set for operation at pressures between 1. 7 and 8. 1 bar (25 and 117 PSI). · The appliance does not require any adjustment or water drain. ELECTRICAL CONNECTION Regulations require that the appliance is earthed. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the prescriptions. Make sure that the installation and the electrical connection are carried out by a qualified technician according to the manufacturer's instructions and local safety regulations. If your new appliance is provided with a plug with no earth wire, connect your green/yellow earth wire (A) to the earth screw located on the appliance (B) (see figure). Ensure that the voltage indicated on the appliance data plate corresponds to the mains voltage. The plug of the appliance must be easily accessible even after installation so that the appliance can be unplugged if necessary. If this is not possible, connect the appliance to the mains supply by means of a two-pole switch with minimum break distance between contacts of 3 mm, fitted at an easily accessible point. If the power supply cable plug and socket are not of the same type, replace the socket. After installation, make sure that the appliance is not standing on the power supply cable. Disconnect the appliance from the power supply by unplugging it. [. . . ] Note: do not unscrew the levelling bolts too much when lowering the appliance as they could fall out. Aligning the doors If, after switching on the appliance and adjusting the refrigerator and freezer doors, the doors are misaligned, disconnect the appliance from the power supply and adjust both doors as indicated in the enclosed diagram. Figure A Figure B 5 6 7 8 [. . . ]