User manual WHIRLPOOL WSE5530 A W INSTRUCTION FOR USE

[. . . ] After replacing the filter, press the "Reset filter/alarm" button until the symbol becomes green. Eu/myfridge Freezer compartment temperature Press the "Freezer temp" button to change the temperature setting. Filter Alarm Reset (Acoustic alarm mute button) Press the "Reset Filter/Alarm" button to stop the acoustic alarm. Anti-bacterial and anti-odour filter (where provided) Change the filter when the symbol blinks. [. . . ] €¢ the power cable isn't broken. • the voltage is correct. €¢ Disable the function (see the Quick Start Guide). If the appliance has a water and ice dispenser: A new appliance takes about a night to reach the ideal temperature Wait for the time required for the temperature inside the freezer to for producing ice. The automatic ice maker may not be enabled (in some models it can be disabled). Water may not reach the automatic ice maker. Refer to the Quick Start Guide to enable the automatic ice maker again (on some models only). Check that the product is connected to the mains water supply and that the water tap is open. Refer to the filter installation instructions to ensure that the filter was installed correctly and is not clogged. If installation or clogging is not a problem, call qualified personnel. The "Standby" (depending on the model) or "Eco mode" function may have been enabled. On hot days or if the room is warm, the motor naturally runs longer. Furthermore, if the appliance door has been left open for a while or if large amounts of food have been stored, the motor will run longer in order to cool down the interior of the appliance. There may be dust or fluff in the condenser. The doors may not be closed properly or the seals may not be intact. If the room is very humid, it is normal for moisture to build up inside the appliance. avoid locations in direct sunlight or near a source of heat. The water filter may be clogged or installed incorrectly. Remove the front plinth (see installation manual) and clean the condenser using a vacuum cleaner. Check that the doors are closed properly and that the door seals do not allow any air infiltration. Install the appliance in a dry, well-ventilated place. Make sure the air ducts inside the compartments are not blocked, as this prevents the circulation of cold air. [. . . ] Signal sounds (if present) There are letters on the display, Malfunction Alarm and an acoustic signal is sounding The alarm indicates that a technical component has malfunctioned. (if provided and not previously disabled). The "Eco mode" function may have been enabled. Close the doors or press the mute alarm button to switch off the acoustic signal. [. . . ]