User manual WHIRLPOOL WSE5531 A SL INSTALLATION

[. . . ] After replacing the filter, press the "Reset filter/alarm" button until the symbol remains permanently on. Drawer / bottom basket (depending on the model) V. Internal light (depending on the model) B. Middle light (depending on the model) C. [. . . ] Press the mute alarm button to switch off the acoustic signal. The This alarm may be activated when the appliance is used for the first appliance needs approximately 2-3 hours to reach the correct time. temperature to store a normal fridge load of food. Replace the filter (see the Quick Start Guide). Replace the filter (see the Quick Start Guide). To replace the filter, refer to the Instructions for Use. The "Water filter" symbol has changed colour. water filter running out/exhausted (where provided). The control panel is off and/or the appliance is not working There may be a problem with the power supply to the appliance Check that: • there has not been a power failure. €¢ the plug is inserted properly into the power socket and the bipolar mains switch is in the right position (i. €¢ the safety protection devices in the domestic electrical system are working. Check that: • the doors close properly. €¢ the appliance is not near a heat source. €¢ the air ducts inside the compartments are not blocked, as this prevents the circulation of cold air. €¢ the "Vacation mode" function is not enabled (see Quick Start Guide) If necessary, lower the temperature. The dispenser does not dispense ice when the lever is pressed. This is normal when the freezer door is open, or if the ice bucket is Close the freezer door and/or check that the ice bucket is installed not installed correctly. The "Child Safety" or "Ice/water dispenser lock" function may have been enabled. Disable the function (see the Quick Start Guide). excessive moisture inside the compartments. It is not cold enough inside the compartments Change the ice selection from "ice cubes" to "crushed ice" or vice versa (in some models only), so as to remove any ice blocks. If the Ice cubes may be stuck because the ice dispenser has not been used dispenser continues not to dispense ice, wait for two minutes and for some time: The dispenser may not have been used for extended then repeat this operation. [. . . ] Reactivate the function by pressing the anticondensation switch in the ice/water dispenser area (marked with an arrow in the figure), depending on the model. There is condensation in the ice The dispenser anti-condensation device may have been disabled and water dispenser area. (depending on the model) The "Compartment door open" Open door alarm. Symbols blinks and an acoustic The alarm is activated when the doors are left open for more than 2 minutes. [. . . ]