User manual WHIRLPOOL WTC 3735 A NFCX PROGRAM CHART

[. . . ] is the recommended Description: LED ON temperature settings. LED OFF To adjust the temperature in the freezer compartment, use the "Fridge / Freezer" button (1) to control the temperature in the freezer cabinet. The temperature in the freezer compartment may be set by the temperature setting pushbutton (3) on the control panel. On the left are described the 5 set points for high temp. [. . . ] When Fresh Control is disabled remember to turn off the fan when there is a lower ambient air temperature. To turn off the fan press the button (1a). If the appliance has the fan it can be equipped with the antibacterial filter. Remove it from the box (found in the crisper drawer (item 7) and insert into the cover of fan (item 1b). The replacement procedure is attached with the filter. DEFROSTING THE REFRIGERATOR COMPARTMENT Refrigerator compartment defrosting is completely automatic. Droplets of water on the rear wall inside the refrigerator compartment indicate that the automatic defrost phase is in progress. The defrost water is automatically run into a drain hole and collected in a container, where it evaporates. DEFROSTING THE FREEZER COMPARTMENT No Frost freezers provide chilled air circulation around the storage areas and prevent the formation of ice, thereby completely eliminating the need for defrosting. Frozen items don't stick to the walls, labeling stays legible and storage space remains neat and clear. D GB F NL E P I GR S N DK FIN PL CZ SK H RUS BG RO PRODUCT SHEET REPLACING THE LIGHT BULB Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: put the fingers into the side ventilation holes (1), stretch the cover gently and move it upwards. If necessary unscrew the broken bulb and replace it with the new one. GUIDE TO SELECTING FUNCTIONS Functions and settings Temperature setting button Temp. °C is used to select the fridge/freezer temperature set-point from among 5 levels (level 1, level 2, level 3, level 4, level 5) by consecutive pressing the button. Alarm deactivation - the user has to press Reset alarm pushbutton. Fast Freezing: For more efficient freezing activate this function 48 hours before freezing fresh products. - Select Freezer compartment by using button (1), LED (2) shall turn ON. - Press and hold the temperature setting button Temp. °C until 3 green LEDs light up simultaneously (4) (5) (6). After 24 hours place the food to be frozen in the upper basket of the freezer compartment. This function is automatically disabled after 48 hours. [. . . ] A short sound signal will be provided for the activation of the Fresh Control. This function controls the fridge fan in order to optimize food preservation in any ambient temperature conditions. To minimize the Energy consumption is suggested to disable the Fresh Control function and fan. OTHER ABNORMAL APPLIANCE OPERATIONS DISPLAYED BY LEDs In case of abnormal appliance operation, all the temperature selection LEDs will flash and one beep will sound. To check the code alarm user have to press and hold the temperature setting Temp. °C & Reset alarm pushbuttons and alarm code will be showing on the temperature LEDs (possible alarm codes are explained in the table below). [. . . ]