User manual WHIRLPOOL WTE2922 NFW PROGRAM CHART

[. . . ] The indicator LEDs on the control panel light up for approximately 1 second, and after initialization process, setpoint is displayed. Note: - If food is placed in the refrigarator before the appliance has cooled completely, it may deteriorate. [. . . ] The fan will run ONLY when the compressor is in operation. Remember to turn off the fan when there is a lower ambient air temperature. If the appliance has the fan it can be equipped with the antibacterial filter. Remove it from the box (found in the crisper drawer (item 7) and insert into the cover of fan (item 1b). The replacement procedure is attached with the filter. ELECTRONIC CONTROL PANEL DESCRIPTION 1. extra low temperature "Fast cooling" 2. temperature selection/Fast cooling (3 sec. minimum) pushbutton D GB F NL E P I GR S N DK FIN PL CZ SK H RUS BG RO PRODUCT SHEET OPERATION DESCRIPTION Temperature adjustment is made with pushbutton (item 5). Temperature setpoint is done for both compartments at one time – fridge and freezer. At first plug-in of appliance factory setpoint is chosen – medium position (item 3). Following table shows set-points level GB ABNORMAL APPLIANCE OPERATION When the product is plugged in to the mains, during first 10 minutes of its performance, possible temperature sensor failure will be displayed according to following table: Refrigerator Refrigerator evaporator & evaporator sensor Refrigerator sensor refrigerator sensor failure failure failure Description: Description: LED OFF LED ON The appliance will work preserving the food stored, but it is necessary to contact after-sales service and provide alarm code. Note: in case of power failure, appliance goes back to normal operation and previously chosen setpoint is restored. [. . . ] If the inside light is not working, it is necessary to: 1. Remove the light cover: move it upwards as shown in figure. [. . . ]