User manual WHIRLPOOL WTE3322 NFS PROGRAM CHART

[. . . ] The indicator LEDs on the control panel light up for approximately 1 second, and after initialization process, setpoint is displayed. Note: - If food is placed in the refrigarator before the appliance has cooled completely, it may deteriorate. - If fresh food is loaded in freezer position 3 on control panel should be chosen. A. [. . . ] To switch on the fan press the button (1a). It is advisable to activate the fan when the ambient air temperature is over 27 ÷ 28°C or if you perceive drops of water on the glass shelves or in the severe humidity conditions. Note: Do not obstruct the air intake area with food items. The fan will run ONLY when the compressor is in operation. Remember to turn off the fan when there is a lower ambient air temperature. If the appliance has the fan it can be equipped with the antibacterial filter. Remove it from the box (found in the crisper drawer (item 7) and insert into the cover of fan (item 1b). The replacement procedure is attached with the filter. ELECTRONIC CONTROL PANEL DESCRIPTION 1. extra low temperature "Fast cooling" 2. temperature selection/Fast cooling (3 sec. minimum) pushbutton D GB F NL E P I GR S N DK FIN PL CZ SK H RUS BG RO PRODUCT SHEET OPERATION DESCRIPTION Temperature adjustment is made with pushbutton (item 5). Temperature setpoint is done for both compartments at one time – fridge and freezer. At first plug-in of appliance factory setpoint is chosen – medium position (item 3). Following table shows set-points level GB ABNORMAL APPLIANCE OPERATION When the product is plugged in to the mains, during first 10 minutes of its performance, possible temperature sensor failure will be displayed according to following table: Refrigerator Refrigerator evaporator & evaporator sensor Refrigerator sensor refrigerator sensor failure failure failure Description: Description: LED OFF LED ON The appliance will work preserving the food stored, but it is necessary to contact after-sales service and provide alarm code. Note: in case of power failure, appliance goes back to normal operation and previously chosen setpoint is restored. LED OFF LED Flashing GUIDE TO SELECTING FUNCTIONS Temperature selection pushbutton (item 5) is used to set desired temperature level, from coldest to warmest . At each short pressure of the pushbutton, the setpoint will change (cyclically). Fast Cooling function The use of this function is recommended when placing a very high quantity of food in the refrigerator compartment. [. . . ] REPLACING THE LIGHT BULB Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: move it upwards as shown in figure. [. . . ]