User manual WHIRLPOOL WTH5244 NFM INSTRUCTION FOR USE

[. . . ] Any damage must be reported to the dealer within 24 hours of delivery of the appliance. 2. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. 3. Installation and the electrical connection must be carried out by a qualified technician according to the manufacturer’s instructions and in compliance with the local safety regulations. 4. Clean the inside of the appliance before using it. SAFEGUARDING THE ENVIRONMENT 1. [. . . ] Second step: removing the central divider located between the drawers • Tilt the divider to the left starting from the back. Third step: removing the crisper drawer lid • Slide the crisper drawer lid outwards. • Remove the lid. Crisper drawer Crisper drawer divider Crisper drawer lid 27 63602042GB. fm Page 28 Monday, January 28, 2008 12:09 PM TO REPLACE THE CRISPER DRAWER LID First step: replacing the crisper drawer lid • Insert the back of the lid into the runners. Second step: replacing the crisper drawer divider • Refit the divider in the specific slots located on the bottom of the compartment and crisper drawer wall as shown in the figure. Third step: replacing the crisper drawers • Replace the drawer on the wheels. • Push it back into place. Crisper drawer lid Crisper drawer central divider Crisper drawer FREEZER COMPARTMENT After switching on the appliance, the freezer compartment takes approximately 3 hours to reach a suitable temperature for frozen food storage. The freezer compartment, marked with the symbol , is used for storing frozen food and freezing fresh or cooked food. Place labels on the inside of clear freezer bags; use self-adhesive labels on the outside of opaque ones. Fasten the top of the bag with a string. DEFROSTING Here are some helpful tips. Raw vegetables: do not thaw, put straight into boiling water and cook as usual. Meat (large cuts): thaw in the refrigerator compartment without unwrapping. Also remove the two big caps on the left. (FIG-1) Remove the two big caps Figure-1 2. Dismantle the refrigerator and frezeer door from cabinet by pulling towards to you together with the middle hinge. Remove the kick plate by pulling forward. Unscrew the bottom hinge fixing screws and remove it. Unscrew the pin of hinge from Hole 1, rotate the bottom hinge 90° and screw the pin to Hole 2. (See Detail A) Then screw the hinge to bottom left side of refrigerator. (FIG-3) Figure-2 Hole 1 Hole 2 Detail-A Bottom hinge and kick plate Figure-3 4. Unscrew the screw fixing the top hinge cover and remove it. Unscrew the two screws fixing the top hinge and remove it. Insert the two big caps that are put in the user manuel bag to left side cap holes. [. . . ] When the door is opened, humidity from the room air enters the refrigerator. The more often the door is opened, the faster humidity builds up, especially when the room itself is very humid. • If the room is very humid, it is normal for moisture to build up inside the refrigerator. • It is normal for droplets of water to form on the back wall after the refrigerator self-defrosts. [. . . ]