User manual WHIRLPOOL WTV45952 NFC IX PRODUCT FICHE

[. . . ] Electronic control panel / light unit 9. Cooler Compartment ( best for meat and fish) 12. Door trays Anti-bacterial protection (depending on the model): - Antibacterial filter in the fan (7) - Antibacterial additives in the Crisper (13) - Door seals are made of material able to inhibit bacterial growth (6). Notes: - Depending on the model the number and type of accessories may vary. [. . . ] - In case it'll have a freezer flap, please remember that to maximize the storage volume it's suggested to remove it. - All shelves and door trays are removable. - Freezer wire shelf can be place in two positions: • In the middle for optimal energy consumption and food preservation • Upper position (recommended for freezing fresh food) - The internal temperatures of the appliance depend on the ambient temperature, frequency of opening the HYDROSENSE SHELVES (depending on the model) The special contour of the HydroSense shelves creates a barrier that contain spills and simplifies cleanup, preventing liquids from leaking onto shelves below. NET SHELF (depending on the model) The Net Shelf is the net which can be used to store little items directly under the glass shelf, taking full advantage of this space. Pull down the net shelf (using the lip on the front) to load/unload it. The net is flexible: do not stress it by loading it with bulky or heavy items. To remove the net (for cleaning purpose, or to use it under another shelf), you have to first remove the glass shelf under which the net is currently placed. The net shelf is dishwashable. HOW TO START THE APPLIANCE After plugging the appliance to the mains, it starts the operation automatically. After starting the appliance, wait at least 4-6 hours before placing food into the appliance. The indicator LEDs on the control panel light up for approximately 1 second, and after initialization process, setpoint is displayed. Note: - If food is placed in the refrigarator before the appliance has cooled completely, it may deteriorate. FAN WITH A BUTTON (depending on the model) The fan improves temperature distribution inside the refrigerator compartment, allowing better preservation of stored food. To activate the Eco Green function press the pushbutton on the control panel to choose the mid-high temperature, as showed here below: TEMPERATURE SELECTION Temperature selection pushbutton is used to set desired temperature level, from warmest to coldest . At each short pressure of the pushbutton, the setpoint will change (cyclically). Temperature adjustment is made with the pushbutton on the control panel. Temperature set-point is done for both compartments at one time - fridge and freezer. At first plug-in of appliance factory set-point is chosen medium position. Following table shows set-points level High temp. Mid-high temp. Middle temp. Mid-low temp. Low temp. Legend LED ON LED OFF Legend LED ON LED OFF D GB F NL E P I GR S N DK FIN PL CZ SK H RUS BG RO UKR CA AE PRODUCT SHEET ABNORMAL APPLIANCE OPERATION When the product is plugged in to the mains, during first 10 minutes of its performance, possible temperature sensor failure will be displayed according to following table: Refrigerator Evaporator sensor failure Refrigerator sensor failure Refrigerator & Evaporator sensor failure GB DEFROSTING THE FREEZER COMPARTMENT The freezer should be defrosted once or twice a year or when excessive frost is present (3 mm thickness). Before defrosting the freezer compartment unplug the appliance or disconnect it from the power supply. Defrosting the freezer compartment should be done manually by open the door till the all of ice will be melted. During defrosting process please wipe the compartment with a rag to avoid water penetration into the product. Before restarting the product make sure that compartment is fully dry. REPLACING THE LIGHT Always disconnect the refrigerator from the power supply before replacing any light bulb. [. . . ] Before restarting the product make sure that compartment is fully dry. REPLACING THE LIGHT Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: move it upwards as shown in figure. Legend LED OFF LED Flashing The appliance will work preserving the food stored, but it is necessary to contact after-sales service and provide alarm code. Note: in case of power failure, appliance goes back to normal operation and previously chosen setpoint is restored. CLEANING Regularly clean the appliance using a cloth and a solution of warm water, with some soft detergent suitable for cleaning the inside of the refrigerator compartment. [. . . ]