User manual WHIRLPOOL WTW5800BW INSTALLATION GUIDE

[. . . ] installing on carpet is not recommended. N Floor must support washer’s total weight (with water and load) of 315 lbs (143 kgs). IMPORTANT: Do not install, store, or operate washer where it will be exposed to weather or in temperatures below 32° F (0° C). Water remaining in washer after use may cause damage in low temperatures. [. . . ] You may need additional parts with separate directions. Place drain hose in standpipe Drain hose form Firmly grasp power cord plug and pull to free from rear panel. Gently place power cord over console to allow free access to back of washer. 5" (114 mm) of drain hose should be inside standpipe; do not force excess hose into standpipe or lay on bottom of laundry tub. Clear water lines For floor drain installations, you will need to remove the drain hose form from the end of the drain hose. You may need additional parts with separate directions. € Run water for a few seconds through hoses into a laundry tub, drainpipe, or bucket to avoid clogs. Make note of which hose is connected to hot water to help in attaching hoses to washer correctly. CONNECT INLET HOSES Washer must be connected to water faucets with new inlet hoses with flat washers (not provided). NOTE: Both hoses must be attached and have water flowing to inlet valves. If you are only connecting to a cold water faucet, you must use a Y-adapter (not provided). Screw coupling by hand until it is snug. IMPORTANT: To reduce risk of hose failure, replace the hoses every 5 years. Record hose installation or replacement dates for future reference. n Periodically inspect and replace hoses if bulges , kinks , cuts , Attach hose to hot water faucet. Screw on coupling by hand until it is seated on washer. use pliers to tighten couplings an additional two-thirds turn. Repeat this step with second hose for cold water faucet. IMPORTANT: Do not overtighten or use tape or sealants on valve when attaching to faucets or washer. Check for leaks Turn on water faucets to check for leaks. A small amount of water may enter washer. 5" (113 (114 mm) Jam nut Models with metal feet or Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with cable tie. [. . . ] Lower the drain hose if the end is higher than 96" (2. Water may splash off basket if washer is not level. Make sure all four fill hose flat washers are properly seated. Pull drain hose from washer cabinet and properly secure it to drain pipe or laundry tub. [. . . ]