User manual WHIRLPOOL WTW8900BW WARRANTY INFORMATION

[. . . ] See “Washer Care” in your Use and Care Guide for winterizing information. Proper installation is your responsibility. 5" (114 mm) 39" (990 mm) Recessed area or closet installation 3" (76 mm) Minimum diameter for a standpipe drain: 2" (51 mm). Top of standpipe must be at least 39" (990 mm) high; install no higher than 96" (2. [. . . ] 2 m) of its final location; it must be in a fully upright position. NOTE: To avoid floor damage, set washer onto cardboard before moving it and make sure lid is taped shut. Remove shipping base To avoid damaging floor, place cardboard supports from shipping carton on floor behind washer. If your washer includes a sound shield, please refer to the instructions included with the sound shield to install it at this time. Attach drain hose to drain port Remove tape from washer lid, open lid and remove cardboard packing tray from tub. NOTE: Keep tray in case you need to move washer later. Free power cord Remove the red plastic plug from the black drain port on the back of the washer. if clamp is not already in place on elbow end of drain hose , slide it over end as shown. Squeeze clamp with pliers and slide black elbow end of drain hose onto black drain port and secure with clamp. For a laundry tub or standpipe drain, go to step 6. For a floor drain, remove the preinstalled drain hose form as shown in Step 7. Check levelness of washer Place level here Place level here If washer is not level: On models with metal feet, use a 9/16" or 14 mm open-end or adjustable wrench to turn jam nuts clockwise on feet until they are about 1/2" (13 mm) from the washer cabinet. Then turn the leveling foot clockwise to lower the washer or counterclockwise to raise the washer. On models with plastic feet, use adjustable pliers to turn the plastic leveling foot counterclockwise to lower the washer or clockwise to raise the washer. on all models , recheck levelness of washer and repeat as needed. Rock washer back and forth to make sure all four feet make solid contact with floor. If washer is level, skip to step 15, (on models with metal feet) or step 16 (on models with plastic feet). HELPFUL TIP: You may want to prop up front of washer about 4" (102 mm) with a wood block or similar object that will support weight of washer. Tighten leveling feet Jam nut Not Level LEVEL Not Level On models with metal feet, when washer is level, use a 9/16" or 14 mm open-end or adjustable wrench to turn jam nuts counterclockwise on leveling feet tightly against washer cabinet. HELPFUL TIP: You may want to prop washer with wooden block. Part, go back through steps to see what was skipped. Q Check that all parts are now installed. [. . . ] Check for any kinks in inlet hoses, which can restrict water flow. Plug power cord into a grounded 3 prong outlet. Washer not draining/ spinning, loads are still wet or spin light remains on (indicating that the washer was unable to pump out water within ten minutes) Incorrect or wrong wash or rinse temperatures, or load not rinsed Check plumbing for correct drain hose installation. Drain hose extends into standpipe farther than 4. [. . . ]