User manual WHIRLPOOL WVI75UC6DS INSTALLATION GUIDE

[. . . ] 4 CM) ISLAND-MOUNT CANOPY RANGE HOOD Installation Instructions and Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www. Com In Canada, call 1-800-807-6777 or visit our website at www. 31 RANGE HOOD SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. [. . . ] see the “Location Requirements” section. Make sure the range hood is centered over the cooking surface. Tape template in place on the ceiling at the marked centerline. The line for the front of the range hood should be parallel to the front of the cooktop. See “Installation Dimensions” in the “Location Requirements” section to help determine the desired dimension for vertical height “B. Install transition on top of hood (if removed for shipping) with 2 - 3. Attach the air deflector to the upper horizontal support using 4 mounting screws. Position the 4 vertical supports (A) with the notches at the bottom and attach to the range hood using 16 - 4. Attach the horizontal support (B) using 8 - 4. 2 cm) duct needed to connect the transition to the deflector. NOTE: Vent should fit up inside the deflector 1" (2. Install vent between the transition and the deflector. NOTE: To make vent installation easier, temporarily remove the deflector from the chimney support bracket and replace after vent section is in place. Continue with “Range Hood Installation” in this section. Using 2 or more people, lift the range hood assembly and attach it by snapping the vertical supports to the spring clips in the upper horizontal support bracket that is mounted to the ceiling. NOTE: The range hood assembly must be held in place while you are installing the screws in the next step. Run home power supply cable through strain relief, into terminal box. Green (or bare) and yellowgreen ground wires Make Electrical Connection WARNING 5. Use UL listed wire connectors and connect white wires (E) together. wARNING Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. [. . . ] This limited warranty is valid only in the United States or Canada and applies only when the major appliance is used in the country in which it was purchased. This limited warranty is effective from the date of original consumer purchase. Proof of original purchase date is required to obtain service under this limited warranty. Commercial, non-residential, multiple-family use, or use inconsistent with published user, operator or installation instructions. [. . . ]