User manual WHIRLPOOL WVW57UC0FS INSTALLATION GUIDE

[. . . ] 4 CM) WALL-MOUNT CANOPY RANGE HOOD Installation Instructions and Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www. Com In Canada, call 1-800-807-6777 or visit our website at www. 27 RANGE HOOD SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. [. . . ] Using 2 or more people, lift range hood onto covered surface. Remove wood base from range hood and dispose of properly. Remove the metal grease filter and the white foam shipping block from inside the range hood located below the blower. Mark centers of the fastener locations through the template to the wall. IMPORTANT: All canopy mounting screws must be installed into wood where possible. If there is no wood to screw into, additional wall framing supports may be required, or use the (4) 10 x 60 mm wall anchors and 5. 8 mm) pilot holes at all locations where screws are being installed into wood. For wall anchors, drill 7/16" (10 mm) holes at all locations where wall anchors are being used. 4 mm) gap between the wall and the back of the screw head to slide range hood into place. For wall anchors, install the 10 x 60 mm wall anchors, and install the 5. 4 x 75 mm screws into the wall anchors. Tighten until the wall anchors are secure. Attach vent cover bracket to wall flush to the ceiling using (2) 5 x 45 mm screws. Use the optional wall anchors if needed. range Hood Mounting Screws Installation 1. Determine and mark the centerline on the wall where the canopy hood will be installed. Select a mounting height between a minimum of 24" (61 cm) for an electric cooking surface, a minimum of 27" (68. 6 cm) for a gas cooking surface , and a suggested maximum of 36" (91. 4 cm) above the range to the bottom of the hood. Tape template in place, aligning the template centerline and bottom of template with hood bottom line and with the centerline marked on the wall. Determine and make all necessary cuts in the wall for the vent system. Install the vent system before installing the hood. [. . . ] Commercial, non-residential, multiple-family use, or use inconsistent with published user, operator or installation instructions. In-home instruction on how to use your product. Service to correct improper product maintenance or installation, installation not in accordance with electrical or plumbing codes or correction of household electrical or plumbing (i. Defects or damage caused by the use of non-genuine Whirlpool parts or accessories. [. . . ]