User manual WHIRLPOOL WVW75UC0DS INSTALLATION GUIDE

[. . . ] 4 CM) WALL-MOUNT CANOPY RANGE HOOD Installation Instructions and Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www. Com In Canada, call 1-800-807-6777 or visit our website at www. 27 RANGE HOOD SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. [. . . ] Aluminum/copper connection must conform with local codes and industry accepted wiring practices. Wire sizes and connections must conform with the rating of the appliance as specified on the model/serial rating plate. The model/serial plate is located behind the filter on the rear wall of the range hood. Wire sizes must conform to the requirements of the National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22. 6 INSTALLATION INSTRUCTIONS Prepare Location ■ It is recommended that the vent system be installed before hood is installed. Before making cutouts, make sure there is proper clearance within the ceiling or wall for exhaust vent. Check your ceiling height and the hood height maximum before you select your hood. 8 mm) pilot holes at all locations where screws are being installed into wood. 4 mm) gap between the wall and the back of the screw head to slide range hood into place. Determine which venting method to use: roof, wall, or nonvented. Select a flat surface for assembling the range hood. Attach vent cover bracket to wall flush to the ceiling using 2 - 5 x 45 mm screws. WARNING Excessive Weight Hazard Use two or more people to move and install range hood. Failure to do so can result in back or other injury. Using 2 or more people, lift range hood onto covered surface. a B Range Hood Mounting Screws Installation 1. Determine and mark the centerline on the wall where the canopy hood will be installed. 4 cm) above the range to the bottom of the hood. Place the assembled air deflector and duct over the exhaust outlet from the hood. Reassemble the air deflector to the duct cover bracket with the 4 assembly screws. Fit vent system over the exhaust outlet. Check that back draft dampers work properly. [. . . ] This limited warranty is valid only in the United States or Canada and applies only when the major appliance is used in the country in which it was purchased. This limited warranty is effective from the date of original consumer purchase. Proof of original purchase date is required to obtain service under this limited warranty. Commercial, non-residential, multiple-family use, or use inconsistent with published user, operator or installation instructions. [. . . ]