User manual WHIRLPOOL WWCR9230B

[. . . ] made of cotton and linen. Normally soiled blouses, shirts, overalls, etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Curtains and delicate clothing, dresses, skirts, shirts and blouses. Woollens, labelled with the Woolmark and identified as machine washable, as well as textiles made of silk, linen, wool and viscose marked as handwashable. [. . . ] - To terminate the “Rinse hold” by draining the water, without any spinning, press the “Start/Pause” button. - To terminate the “Rinse hold” by spinning the laundry, press the “Spin” button to select the desired spin speed and then “Start/Pause” to start the spin cycle. - Do not leave the laundry to soak for too long in the “Rinse hold”. up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Drain/Spin. CHILD LOCK Activating the child lock prevents children from starting a wash cycle or changing the settings of a running programme. The child lock cannot be activated or deactivated when the programme selector is in the “Off/O” position. To activate the child lock: • Turn the programme selector to a programme position, or run a programme as usual. • Press the 2 buttons marked with the key symbol simultaneously for at least 3 seconds. A key-like symbol will shortly appear on the display to indicate that the child lock is active. Any time you try to change a programme setting with active child lock, the display will briefly show the key-like symbol. The programme setting cannot be changed anymore. The only change possible is to switch the washer off by turning the programme selector to the “Off/O” position. To deactivate the child lock: • Press again the 2 buttons marked with the key symbol simultaneously for at least 3 seconds. SET A START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Select programme, temperature, spin speed and options. • Press the Start delay button to select a delay time up to 23 hours. • Press the “Start/Pause” button . The countdown of the delay time begins; the start delay symbol and the colon between hours and minutes blink. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • If you use the “Dosing Aid” button: select the delay time BEFORE pressing the “Dosing Aid” button. The countdown of the selected delay time begins after having pressed the “Start/Pause” button for the second time (see separate Instructions for Use concerning the “Dosing Aid”). To cancel the “Start delay” . . . before you press the “Start/Pause” button: • Press the “Reset/Drain” button , or set the start delay time to “0:00” - the delay time disappears after a few seconds. . . . after having started the programme: - Press the “Start/Pause” button - the delay time disappears from the display. Press “Start/Pause” again if you want to start the selected programme immediately. Consumption values were measured in normalized conditions, in compliance with IEC/EN 60456. [. . . ] Press the “Start/Pause” button to pause the programme. Select the new programme, temperature, any options and another spin speed if you want. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. [. . . ]