User manual WHISTLER 1670

[. . . ] OWNER'S MANUAL 1670 LASER/RADAR DETECTOR TM If you have questions concerning the operation of this Whistler product please call consumer relations: 1-800-531-0004 Hours: Monday - Friday 8:00 am - 5:00 pm CST Please keep the receipt in a safe place. If the unit is returned without a dated proof of purchase an out of warranty service charge applies. Note: Your warranty period begins at the time of purchase. The warranty is validated only by return of the Warranty Validation card. [. . . ] The unit will beep once; this enters Memo mode. Display reads: PLAY RECORD MEMO 16 OPERATION · Press and release the (Quiet/Record) button to begin a recording. Note: Recording starts as soon as the button is released. Display reads: REC1 8 REC = record, 1 = track #, 8 = time remaining If the recording time expires for a track, the unit will automatically switch to the next track. Press and release (Quiet/Record) again to stop recording. The unit will automatically stop recording once track 6 is completed. To play a message: · Enter Memo mode and press (Power/Play) to listen to recorded messages. · To play a selected track, press (Volume Up) or (Volume Down) button until selected track appears on the display. Display reads: PLY1 8 PLY = play, 1 = track #, 8 = time remaining · Press the (Power/Play) button. Messages are kept in memory and are not affected by resetting the factory features. See "Reset Features" section of the manual. To delete a message: · Enter Memo mode and press (Volume Up) or (Volume Down) button until selected track appears on the display. · Press the (Quiet/Record) button twice. 17 OPERATION To exit Memo mode: · Press (Volume Up) or (Volume Down) buttons simultaneously and release. NOTE: Memo mode automatically exits within 20 seconds if a button is not pressed. Vehicle Battery Saver Mode The Vehicle Battery Saver Mode automatically shuts off your detector within 3 hours if you forget to turn it off. The timer is reset if the detector is turned off, unplugged or any button is pressed before the 3 hours have expired. The detector will alert you with an audible and visual warning before it shuts off. Display reads: PWR OFF During this warning you can momentarily reset the unit by pressing any button. If the unit has automatically turned itself off, press the (Power/Play) button to turn the unit back on. You can manually engage the Vehicle Battery Saver Mode by pressing and holding the City button until one beep is heard. Refer to "Option Select Mode" for instructions for deactivating battery saver mode feature. 18 RADAR ALERTS Speed Radar Audio/Visual Alerts When X, K or Ka is detected the band ID and signal strength is displayed. The audio alert is continuous and has a geiger counter-like pattern. [. . . ] Be certain your unit is returned with its serial number. For reference, please write your unit's serial number in the following space: s/n __________________. Units without serial numbers are not covered under warranty. IMPORTANT: To validate that your unit is within the warranty period, make sure you keep a copy of your dated proof of purchase and return the Warranty Validation card. 29 WARRANTY INFORMATION Service Out Of Warranty Units will be repaired at "out of warranty" service rates when: · The unit's original warranty has expired. [. . . ]