User manual WHISTLER XTR520

[. . . ] OWNER'S MANUAL Dear Whistler Owner, If you have questions concerning the operation of this Whistler product please call: CuSTOmer SeRVICE 1-800-531-0004 Total Band Protection XTR-220/520 Monday - Friday · 8:00 am - 5:00 pm CT TM or visit our website www. whistlergroup. com Please keep the receipt in a safe place. You may regisw ter your product online at www. whistlergroup. com. For warranty verification purposes, a copy of your dated store receipt must still accompany any unit sent in for warranty work. If the unit is returned without a dated store receipt an out of warranty service charge applies. [. . . ] When selecting options, the, or quiet musted be pressed within 20 seconds or options mode will automatically be exited. To enter: Stay Alert Feature OPERATION XTR-520 Chart Press: Quiet 1st Time 2nd Time 3rd Time 4th Time 5th Time 6th Time 7th Time Display Reads: TONE 3 TEST YES VG-2 OFF SR ON VOICE ON POP ON B SVR ON To Change: Option: = YES Tone 1, 2, 3 = NO (3 different X, K, Ka Patterns) = ON X, K, Ka Audio = OFF tones 1 beep during Power Up = ON Turns VG-2 On = OFF Turns VG-2 Off = ON Turns Safety Radar = OFF On = ON = OFF = ON = OFF = ON = OFF Real Voice Engaged POP On POP Off Battery Saver On Battery Saver Off Vehicle Battery Saver Mode The Vehicle Battery Saver Mode automatically shuts off your detector if you forget to turn it off. The timer is reset if the detector is turned off, unplugged or any button is pressed before the timer has expired. The detector will alert you with an audible and visual warning before it shuts off. During this warning you can reset the unit by pressing any button. If the unit has automatically turned itself off, press the Power button to turn the unit back on. You can manually engage the Vehicle Battery Saver Mode by pressing and holding the City button until one beep is heard. (XTR-520 Only) Refer to "Option Select Mode" for instructions for deactivating battery saver mode feature (XTR-520 Only). XTR-220 Timer = 6hrs XTR-520 Timer = 3hrs The Stay Alert Feature is designed to test a driver's alertness. To engage (when unit is not alarming) : · Press and hold City for approximately 2 seconds. Release button during or immediately after the alert is given. --XTR-520 only: Display shows: Within 30-60 seconds two beeps are sounded; to show alertness, the driver must press either the City, Volume, or Quiet buttons within 3-5 seconds. If a button is pressed within 3-5 seconds, the cycle is repeated. If a button was not pressed within 3-5 seconds alarm sounds and the display shows: --XTR-220 only: The "H" or "C" will flash indicating Stay Alert is activated. Within 30-60 seconds two beeps are sounded; to show alertness, the driver must press either the Volume, City or Quiet button within 3-5 seconds. If the button is pressed within 3-5 seconds, the cycle is repeated. If a button was not pressed within 3-5 seconds, alarm sounds and the display will flash all LED's. · Press Power to exit for both models. Stay Alert is NOT intended as a substitute for adequate rest. You should NOT operate a vehicle if you are drowsy. During extended periods of vehicle operation, you should take frequent breaks. Improper reliance on the Stay Alert feature may result in vehicle damage, personal injury or death. [. . . ] Ship the unit in the original carton or in a suitable sturdy equivalent, fully insured, with return receipt requested to: Whistler Repair Dept. 72756 Please allow 3 weeks turnaround time. IMPORTANT: Whistler will not assume responsibility for loss or damage incurred in shipping. Therefore, please ship your unit insured with return receipt requested. [. . . ]