User manual WILFA POWERFUEL BLENDER PB2B-P1200

[. . . ] Please read this manual carefully before operation and save it for future reference. Before plugging in the appliance, check that the electrical rating shown on the rating plate corresponds with your household electricity supply. Never immerse the base unit of the appliance in water or other liquid, or rinse it under the tap, in order to avoid risk of short-circuit or electric shock. If there is water inside the base unit, please contact an authorized service agent. [. . . ] By continuing to turn the speed dial clockwise, the speed will gradually increase, finally achieving maximum speed. During operation, the work indicator lamp will turn white. The blender will automatically turn off after 10 minutes. To reset the blender for the next operation, turn the speed dial back to the OFF position. Preset Program Key: To use the preset programs, the blender should first Be in Stand-By Mode, then select and rotate the Speed Dial from the OFF Position to the desired preset program setting and when finished press the To stop the blender during operation of one of the programs, press the ON/ OFF button to stop the blender. After operation of the preset program, the blender reverts to stand-by mode. Increases to Speed 7 in 7 sec, then increases to Speed H in 3 sec, and keeps at this speed until finish. Soft start to Speed H for 8s, and stop for 2s. Repeats the cycle until the total operation time is 30s. Insert the measuring cup in the lid by aligning the two tabs in the slots on the lid and twisting to lock. Then push the lid onto the blender jug to close it. Unplug the appliance from the wall socket. Do not immerse the base unit or power cord in water or other liquids. Clean surface of the blender jug with a soft cloth or sponge. the measuring Cup can be disassembled for cleaning. The blender jug can be rinsed with water. it can also be cleaned by pouring 2 cups of water into the blender jug, closing the lid and then operating the blender in Pulse Mode. Then pour out the water and dry with soft cloth. After cleaning, place the blender jug on its side or upside down (Note 1) to dry. Note: If you place the blender jug in upside down position, please remove residual water with a dry cloth. Do not leave it close to the sink or basin in order to avoid water spraying onto the bottom part of the jug. This may cause the bearing to rust, thus affecting the performance of the blender The blender cannot be operated if: ­ The jug is not firmly positioned on the base. [. . . ] The guarantee covers production failure or defects that arise during the guarantee period. Your purchase receipt works as proof towards retailer if claiming your guarantee. The guarantee is valid only for products that are bought and used in private households. The guarantee is not valid if the product is used commercially. [. . . ]