User manual WINCHESTER PIGEON GRADE XTR TRAP

[. . . ] ˎ Do not leave the product in a car in hot weather. ˎ Do not store or use the product in a hot and humid place such as in a sauna bath. ˎ Do not disassemble, crush or pierce the product. ˎ Do not expose the product to excessive shock such as dropping from a high place. [. . . ] Owner’s Record STRANGULATION HAZARD The model and serial numbers are located on the rear of the receiver (under the belt clip). Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. For customers who purchased this product in the USA Please register this product on line at http://www. Proper registration will enable us to send you periodic mailings about new products, services, and other important announcements. Registering your product will also allow us to contact you in the unlikely event that the product needs adjustment or modification. WARNING To reduce fire or shock hazard, do not expose the unit to rain or moisture. IMPORTANT SAFETY INSTRUCTIONS -SAVE THESE INSTRUCTIONS DANGER TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, CAREFULLY FOLLOW THESE INSTRUCTIONS If the shape of the plug does not fit the power outlet, use an attachment plug adaptor of the proper configuration for the power outlet. Keep the cord out of the reach of children (more than 0. To prevent cord entanglement and strangulation: ˎ Do not place the camera or AC adaptor cord within reach of children. ˎ Do not place the camera or AC adaptor cord in, or attach it to, a crib or playpen. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e. ) is not more than that necessary for successful communication. , 8 Ω Dimensions: When the stand is closed Approx. Projecting parts and antenna When the stand is open Approx. 7 W W *  hen operated with the screen kept on, medium volume level, and Voice Activation off AC adaptor: Input: 100 V - 240 V AC, 50 Hz/60 Hz, 0. Design and specifications are subject to change without notice. C Camera (Transmitter) Caméra (Émetteur) Power indicator light Voyant d’alimentation  (power) button Touche  (alimentation)  Antenna Antenne Day/Night sensor* Capteur jour/nuit* Camera Caméra DC IN 5 V jack Prise DC IN 5 V Temperature sensor Capteur de température English Built-in battery When the receiver is connected to the AC adaptor and the built-in battery has discharged to a certain level, the built-in battery starts charging automatically and is charged up to full charge. Installation 2 1 1 Customizing the Video Nursery Monitor Adjusting the volume Press the VOL+ button to turn up or the VOL– button to turn down the speaker volume of the receiver. No sound Note ˎ If you do not attempt to change settings for a certain time, the display returns to the normal screen. [. . . ]  - ) You can set the lowest and highest allowable limits for the temperature of the place where the camera is installed. The alarm sounds if the temperature goes beyond this range. Note ˎ If you do not attempt to change settings for a certain time, the display returns to the normal screen. 1 Connect the supplied AC adaptor to the DC IN 5 V jack and plug it into a wall outlet. [. . . ]