User manual WYSS MENAGE6250

[. . . ] Changing the spin speed/Selecting rinse hold . End of the wash cycle/Removing the washing . If the wash results are not satisfactory . 4 4 5 5 6 8 9 9 9 9 10 11 11 12 12 12 12 12 13 13 13 13 13 14 15 16 16 18 19 20 21 22 22 23 23 23 23 24 25 26 26 26 27 28 31 Installation and connection instructions. [. . . ] Unscrew the hose, take out the filter and clean it. Check the tap and have it repaired, if necessary. Adjust the feet as described in the installation and connection instructions. Always load the drum as full as possible. Mix large and small items. 16 Problem Possible cause Screw connection on the inlet hose is leaking. Drain hose is leaking. Remedy Screw the inlet hose on tightly. Load washing carefully for the next wash. Close off emergency drain hose properly. Follow the manufacturer's instructions exactly when measuring out detergent. Turn off the tap, remove the mains plug from the power point and inform the Customer Care Department. Drain pump cover is not closed Water is running out from under properly. Possibly too much detergent was used. The drain pump runs constantThe Aqua Control anti-flood system ly, even when the machine is has responded. Warning: The water that comes out of the emergency drain hose may be hot. Let the water cool before performing an emergency drain. Open the plinth flap and remove it. 1 Warning: Before emergency draining, switch 2. Remove the emergency drain hose from the retainer and pull it out a little. 3. Place a shallow receptacle underneath it. Then undo the sealing cap of the emergency drain hose. If it is necessary to empty the receptacle more than once, seal up the emergency drain hose with the sealing cap while you are doing so. When the water has all drained away: 5. Use the sealing cap to close the emergency drain hose. Push the emergency drain hose in a little and place it in the holder. Insert the plinth flap into place and close it. 19 Drain pump The drain pump is maintenance-free. Opening the cover of the drain pump is required only in the event of a malfunction when no more water is being pumped out, e. g. [. . . ] Otherwise the water running out can force the hose out of the basin. ­ When pumping the water out, check that the water is running away fast enough. Pumping heights of over 1 metre The washing machine's drain pump is able to pump water to a height of 1metre, calculated from the surface on which the appliance is installed. If pumping height is over 1 metre, malfunctions and damage to the appliance may arise. For pumping heights over 1metre a conversion kit can be obtained. [. . . ]