User manual X10 CR14A

[. . . ] ScanPad Remote For use with Ninja TM Model CR14A TM Pan `n Tilt Camera Bases The CR14A Remote lets you move the position of an XCam2 camera (attached to a Ninja Pan `n Tilt Base) from left to right (pan) and up and down (tilt). You can store 4 positions for a camera and then use the remote to sweep between these positions. [. . . ] Pressing any of these turns on that camera, and turns the other 3 off (Transceiver required). Sweeps thru the 4 stored positions for the selected camera. To clear all stored positions: Move the switch at the bottom to Program. Press Center then move the switch back to Normal. With the switch set to Normal: Press P1, P2, P3 or P4 to move to any of the 4 positions stored for the camera. Press Center to center the position for the camera. Press Sweep to sweep through all 4 positions stored for the camera. To stop scanning or movement to a stored position: Press any BLUE key on the remote while the camera is moving to stop the movement. To turn the camera off: Unplug its power supply. For multiple camera systems a Transceiver is required, which then lets you turn the cameras on and off by remote control. Multi Camera Operation If you purchase multiple Pan 'n Tilt Cameras, and purchase a Transceiver (RR501 or TM751) the Remote lets you turn on any of 4 cameras or scan each of them in turn (forward or backward) so as to display the image from each camera in turn on your TV. You connect each camera (up to 4) to its own Ninja Base, plug each one into its Addressable Power Supply, and set each to a different number between 1-4, 5-8, 9-12, or 13-16. [. . . ] (For multiple camera systems). See: http://www. x10. com/support/return_policy. htm for warranty info. X10. com, a Div. For additional help, visit www. x10. com/support CR14A-11/02 [. . . ]