User manual X10 IR18A

[. . . ] IconRemote (Single User) TM Owner's Manual Model IR18A Table of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Button Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 DVD/SAT Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Enter the 4-digit code from the code tables (on separate sheet). Note: After a valid code entry, the indicator turns off. For an invalid code, the indicator flashes. If the device responds, no further programming is required. Note: If some buttons do not operate your equipment, try one of the other codes for your brand. Write your codes down here for easy reference later. Type TV VCR DVD CBL AUX Type stored TV Code Code Search If your product does not respond after you have tried all the codes for your brand or if your brand is not listed, try searching for your code by following these steps. Turn on the device (TV, VCR, etc. ) to be controlled. Press and hold SETUP until the indicator remains on, then release SETUP. Repeatedly press SELECT to select the desired mode (TV, VCR, etc. ), unless the desired mode is already selected. Press CHANNEL UP repeatedly (up to 300 times) until the device to be controlled changes channels. The indicator blinks off with each button press. Press and release MUTE to install the code. Cable codes appear under CBL (Cable), etc. If you want to store a VCR code under CBL, first follow the procedure for Direct Code Entry and select CBL in Step 2 of Direct Code Entry. Then enter any VCR code in Step 3 of Direct Code Entry. Then follow the steps above for Code Search. Note: If the device does not have a CHANNEL UP button, use PLAY (VCR only) or POWER instead. Code search begins from the currently stored 4-digit number under that mode. Code Identification Feature The Code Identification Feature lets you identify the 4digit library code stored under your device key. If you want to find what 4-digit code is stored under any device mode, follow these steps. Press and hold SETUP until the indicator remains on, then release SETUP. Repeatedly press SELECT to select the desired mode (TV, VCR, etc. ), unless the desired mode is already selected. [. . . ] If there is a learning problem, the indicator blinks for 3 seconds and stays on. Repeat Steps 4-6 for other buttons you want your remote to learn. Press and release SETUP when all desired remote commands are learned. Code learning is now complete. 4. 2. 1. [. . . ]