Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual X10 MS18A. We hope that this X10 MS18A user guide will be useful to you.
Lastmanuals help download the user guide X10 MS18A.
Detailed instructions for use are in the User's Guide.
[. . . ] This initializes the Motion Detector and picks a random code that is used when it is registered with the Console. Place the unit face down, so that it won't see any motion during the registering process below. Registering the Motion Detector with the Console Press either of the Menu Start up/down buttons (under the Console's lid to the left of the display). [. . . ] Repeat this for any other Motion Detectors you want to register. The display increments to ZONE 4 SET, etc. as you install more Motion Detectors.
Testing the Motion Detector · Set the slide switch on the Motion Detector to position 1. · Press and hold the TEST button for about a second. The LED flashes twice when you release it. · Wait 20 seconds for the Motion Detector to settle. · Walk in front of the Motion Detector. The indicator LED lights each time it senses movement. Check the coverage area and reposition the sensor as required. · Press the TEST button to return to normal operating mode. Note: The Motion Detector will automatically return to normal operating mode after about 2 minutes.
Battery Replacement If a zone has not reported in during the last four hours, the display will show PROBLEM. This is most likely caused by dead batteries. As long as the batteries have not completely failed they can be replaced with fresh batteries without the need to reinstall the Motion Detector. After removing the old batteries fresh batteries must be fitted within 30 seconds to ensure that the security code is retained. To test the Motion Detector: Once the batteries have been replaced, the Motion Detector should be tested as follows: · Make sure the system is NOT armed. · Press the TEST button on the back of the Motion Detector. The Console chimes to acknowledge and the zone # is displayed on the LCD. If the batteries had failed, the security code will have been lost. [. . . ] The Owner's Manual for the Security System describes the full installation process for the Security System, and should be referred to as a supplement to this instruction sheet. *Note: Door/Window Sensors and Motion Detectors may be added in any combination up to a total of 30, e. g. 15 Door/Window Sensors and 15 Motion Detectors, or any combination up to a total of 30 . [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE X10 MS18A
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual X10 MS18A will begin.
