User manual X10 PK9000

[. . . ] If you installed any (optional) X10 Light Control Modules, five seconds after barking starts RoboDog will turn on any X10 Modules which are set to A1. The barking will stop approximately 30 seconds later, or press the top right (1-OFF) button on the KR19A remote to tell RoboDog to stop barking. If you installed any optional X10 light control modules, you can turn on any module set to A2 from the 2-ON (bottom left) button on the KR19A key chain remote. (Modules set to A1 will turn on when RoboDog starts barking). [. . . ] This motion detector can also turn lights on at dusk and turn them off again at dawn. To set up an (optional) DM10A Motion Detector Remove the screw from the front cover on the Motion Detector and remove the cover. Unclip the Motion Detector from the back plate. Remove the 2 screws from the battery compartment cover. Insert 4 AA alkaline batteries (observe polarity). Attach the back plate to an exterior wall in a location where the Motion Detector will see any intruder who approaches your home. Clip the Motion Detector onto the back plate. Adjust the swivel up and down for best coverage. Wait for approximately 60 seconds after installing the batteries to let the sensing circuitry settle before testing the unit. PK9000 inst 10/01 Page 1 of 2 To test the Motion Detector Make sure the slide switch on the back of RoboDog is set to RUN (to the left). Arm RoboDog, by pressing the button on the back. The small red light on the back turns on. Five seconds after barking starts RoboDog will turn on Lamp Modules (which are set to A1). The barking will stop approximately 30 seconds later. If the Motion Detector is tripped again the sequence repeats itself, if no motion is detected for 4 minutes, RoboDog goes quiet, and the Lamp Module set to A1 will turn off. Note: after the Motion Detector has been tripped it will not trip again for a period of 30 seconds (for longer battery life). Press the button on the back of RoboDog to disarm it, the red light goes off. Note: the KR19A key chain remote normally controls X10 codes A1 and A2. To change the KR19A's Housecode · Press and hold the first (top) ON button. 3 seconds later, the LED blinks the current setting: 1 blink for Housecode A, 2 blinks for B. . . . . · Release the first (top) ON button. · Press and release the first (top) ON button the appropriate number of times for the Housecode you want to set. IMPORTANT: Hold the button on your last press. [. . . ] If this equipment does cause interference to radio or television reception, which can be determined by unplugging the equipment, try to correct the interference by one or more of the following measures. q Reorient the antenna of the radio/TV experiencing the interference. q Relocate the product with respect to the radio/TV. q Move the product away from the radio/TV. [. . . ]