User manual X10 PR511

[. . . ] · Direct sunlight should not fall on the Motion Monitor lens. · The Motion Monitor should not face reflective surfaces such as a swimming pool or large windows. · Do not mount the Motion Monitor over heat producing vents or air conditioning units. · The Motion Monitor cannot "see" through glass. [. . . ] 150W, not supplied) into each lamp holder. CONTROLS AND SETTINGS Adjusting the Motion Monitor Coverage · Set the DUSK control fully clockwise to LIGHT. · Set the RANGE control fully clockwise to MAX. · Set the TIME DELAY to 0. 1 minutes (approx. 6 seconds) using a flathead screwdriver. · Swivel the sensor head toward the area you want to cover. Be sure the sensor head remains level from side-to-side and level with the ground. · Aim the floodlights at the area you want to light. · Turn on the power and wait for one minute. Whenever the sensor "sees" you the floodlights turn on and remain on for six seconds after you stop moving. If necessary, reorient the sensor head so normal road traffic does not activate the Motion Monitor. Dusk control After checking that the unit works during the day with the Dusk setting turned fully clockwise, you might want to set the unit to only operate at night. The best setting for the dusk control is indicated by the index mark. This setting should be tried before making any further adjustments. The setting of the dusk control is quite sensitive, so only make small adjustments each time. Index mark · Turn the control toward DARK if the Motion Monitor operates too early in the day. · Turn the control toward LIGHT if the Motion Monitor operates too late in the day. · Turn the control all the way to LIGHT for the Motion Monitor to work all the time. Note: When you change the setting of this control, or when the light level changes, the new setting does not take effect until 10 minutes after the setting was changed or the light level changed. Live Range control Neutral Insulating ring Note: The Motion Monitor has a special lens that "looks" downwards. It must therefore be mounted to face outwards horizontally, i. e. do not "aim" the sensor downwards. Ground · Turn towards MAX to increase range. · Turn towards MIN to avoid traffic, pets or small animals triggering the Motion Monitor. Time Delay switch · Set to desired time for lights to stay on after no further motion has been detected. 4 5 TROUBLESHOOTING Controls and Settings, cont. This Unit switch · Set to SENSOR to have the floodlights turn on when motion is detected. · Set to DUSK to have the floodlights turn on at dusk and off at dawn. Problem: Sometimes the Motion Monitor seems less sensitive than other times. [. . . ] (For example, if the Start Code is set to 3 and the Sensor Switch labeled 6 is set to IN, the module with unit code 9 and the same House Code as the Motion Monitor will turn on at dusk, and turn off at dawn). Caution: To avoid the risk of fire or injury ensure that potentially hazardous appliances such as portable heaters or fans will not be accidentally controlled by the Motion Monitor. Choose controlled Unit Codes carefully. http://www. x10. com/support for more help. 6 7 X10 Wireless Technology, Inc. Limited One Year Warranty X10. com, a division of X10 Wireless Technology, Inc. [. . . ]