User manual X10 RC1310

[. . . ] · Reorient the antenna of the radio/TV experiencing the interference. · Relocate the Console with respect to the radio/TV. · Move the Console away from the radio/ TV. · Plug the Console into an outlet on a different electrical circuit from the radio/ TV experiencing the interference. [. . . ] MASTER RESET immediately takes you back to the HOME CONTROL screen. Enter your new PIN (4 digits). Note, choose a PIN that you are not likely to forget (a birthday, for example). If you forget your PIN you will not be able use the system. If you do forget your PIN contact www. x10. com to find out how to reset your system. If you press Clear while entering numbers, before you're finished setting the new PIN, it clears the numbers. If you press Clear after you've set the new PIN and pressed OK, you are asked to confirm, 1. Pressing 1 takes you back to the HOME CONTROL screen. Pressing 2 stays in INSTALL mode. 24 25 Installation Setting Options Press either of the Menu up/down buttons (under the lid to the bottom right of the display). The display then shows ENTER PIN (Personal Identification Number) in the top line. ENTER PIN 12:00 am The default PIN is 0000, you'll find out later (page 24) how you can change this, but for now press 0000 on the keypad (under the lid to the bottom right of the display). The display shows UNIT NUMBER on the top line. Using the number keys, enter a valid number (1-16) and press OK. UNIT NUMBER Say for example you enter 12. TIMER 12 ON : Enter your desired ON time with the number keys followed by am or pm in the format shown below, (or just press OK if you don't want to set an ON time). The bottom line displays a colon, : **** 12:00 am This takes you to the first level of the menu at step 1. TIMER 12 OFF : Press an up or down menu button until you reach the SET TIMER menu, and then press OK to go to the screen below (or press 9 to go to the NEW TIMER menu): Enter the OFF time as above and press OK, (or just press OK if you don't want to set an OFF time). DAILY on the bottom line (top line blank). DAILY You will see NEW TIMER on the top line. If no timers have yet been entered the up and down Menu buttons will do nothing. If there are other timers already in memory the up and down buttons will cycle around them and will always include NEW TIMER in the loop if there is empty space in the memory. NEW TIMER Using the up or down Menu buttons you can cycle around 1. [. . . ] You connect the lights you want it to control to X10 Lamp Modules and Wall Switch Modules (sold separately). The Security Console also acts as a "Transceiver" and passes commands received from wireless remote controls onto your house wiring, so you can use X10 wireless remote controls to control the same lights that the Security System flashes. You can also use the X10 remote controls to control Appliance Modules, etc. The Security Console also works with X10 EagleEye and ActiveEye wireless motion sensors, again acting as a Transceiver, to pass the commands from the motion sensors to the X10 Modules. [. . . ]