User manual X10 VK58A

[. . . ] Follow Instructions - All operating and use instructions should be followed. Cleaning - Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Attachments - Do not use attachments not recommended by the product manufacturer as they may cause hazards. [. . . ] Never spill liquid of any kind on the product. Servicing - Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. Damage Requiring Service - Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) b) When the power-supply cord or plug is damaged, If liquid has been spilled, or objects have fallen into the product, c) d) If the product has been exposed to rain or water, If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation, e) f) If the product has been dropped or damaged in any way, and When the product exhibits a distinct change in performance - this indicates a need for service. 19. Heat - The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products including amplifiers) that produce heat. FCC CAUTION THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. This equipment generates and uses radio frequency energy, and if not installed and used properly, that is, in strict accordance with the manufacturers instructions, it may cause interference to radio and television reception. It has been type tested and found to comply with the limits for remote control devices in accordance with the specifications in Sub-Parts B and C of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by unplugging the equipment, try to correct the interference by one or more of the following measures. · Reorient the antenna of the radio/TV experiencing the interference. · Relocate the equipment with respect to the radio/TV. · Move the equipment away from the radio/TV. · Plug the equipment into an outlet on a different electrical circuit from the radio/TV experiencing the interference. · If necessary, consult your local Dealer for additional suggestions. NOTE: Modifications to this product will void the user's authority to operate this equipment. 4 5 CONTENTS CONTROLS AND CONTROLS CAMERA/VIDEO SENDER AND CONNECTIONS VIDEO RECEIVER (BOTTOM VIEW) CONNECTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 CAMERA/VIDEO SENDER, REMOTE CONTROLLED . . . . . . . . . . . . . . . . . . . . . . . POWER SUPPLY, AND VIDEO RECEIVER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 CAMERA/VIDEO SENDER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 VIDEO RECEIVER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 TV 2. 4 GHz Video Antenna Channel Switch TV CHAN NEL CONNECTING UP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Set the channel switch to the same letter as you set on the camera, A, B, C, or D. Position the Video Receiver in a convenient location such as on top of the TV and orient the antenna so that the flat side points in the direction of the room where you set up the Camera/Video Sender. VIDEO AUDIO IN DS S IF YOUR TV DOES NOT HAVE A/V CONNECTORS You can use the supplied coaxial cable to connect the TV OUT socket on the Video Receiver to the Antenna input on your TV. If you already have an antenna connected to your TV, you will need to use a TV antenna splitter. TO TV VIDE O A UDIO Set your TV and the TV Channel switch on the Video Receiver (on bottom) to the same channel (3 or 4). TO TV ANTENNA TV 1 2 UH F/VHF AN TENNA 12 13 FINE TUNING YOUR SYSTEM WARRANTY 12 MONTH LIMITED WARRANTY X10 WIRELESS TECHNOLOGY, INC. (X10WTI) WARRANTS ITS PRODUCTS TO BE FREE FROM DEFECTIVE MATERIAL AND WORKMANSHIP FOR A PERIOD OF ONE (1) YEAR FROM THE ORIGINAL DATE OF PURCHASE AT RETAIL. [. . . ]