User manual X10 VK62A

[. . . ] MODEL VK62A ENTER NTERT UR81A ENTERTAINMENT REMOTE ANYWHERE REMOTE WITH RECEIVER MR26A RF RECEIVER WNER' MANUAL OWNER'S MANUAL READ THIS FIRST R EAD T HIS F IRST ! CONSIDERA ONSIDERATIONS S AFETY C ONSIDERATIONS Remember to exercise good common sense when using the Home Automation features of your UR81A Remote - especially when controlling unattended devices. There can be some unexpected consequences if not used with care. For example, an empty coffee pot can be remotely turned on. If that should happen, your coffee pot could be damaged from overheating. [. . . ] Enter the 3 digit Code from the Library Code Table (separate sheet). The LED turns off after the last digit entered. Point the remote at the device and press the POWER button. If the device responds, setup is complete. 5 3 2 6 4 10 11 Notes: 1. The TV mode key can only be used to store TV codes but you can store a code for ANY device under either the VCR, CBL, or AUX mode key. E. G. , you can store a Cable code under the VCR key, or a Satellite code under the Cable key, etc. If your TV/VCR/Cable Box does not respond, try the other codes for your brand. If it still doesn't respond, try the Code Search method below. If the LED blinked rapidly when you entered the code, you may have entered an invalid code. Recheck the code in the code list (separate sheet) and try again. If some buttons do not operate your equipment, try one of the other codes for your brand. When searching for a code (as described below) you might have to press CHANNEL+ many times (50+). RF signals can go right through walls, so you can use the remotes to control lights or appliances from anywhere in your home. H OUSE CODES CODES C ONTROLLERS MODULES AND M ODULES The first thing you need to understand is that there are two different devices you need to control your house; Controllers and Modules. Any light or appliance that you want to control is plugged into a Module and that Module is then plugged into a standard AC outlet. Modules receive commands from Controllers. Examples include the Lamp Module (sold separately). The Transceiver Module (also sold separately) is another example (although it also doubles as a controller as described later). Controllers are also plugged into standard wall outlets and send commands to Modules over your existing electrical wiring in your house without affecting your electricity in any way. The Transceiver Module works as a controller when it is used with a remote control such as the UR81A Remote. When the Transceiver Module receives a command from a remote it sends digital signals over your existing house wiring to a Module which receives the signals and executes the command. 14 AND U NIT C ODES UNIT CODES Each Module has a specific address made up of a House Code (red dial on the face of the Module) and a Unit Code (black dial on the face of the Module). The Remote sends a wireless signal to a Transceiver which retransmits it over the AC wiring to the Module. Only the Module with a matching address executes the command. If more than one Module has the same address, both Modules execute the command. Addresses are set on the Module by turning the two dials on the front of the Module to the desired letter and number (using a small screwdriver or a coin). [. . . ] If the Transceiver Module doesn't respond to the remote: · Check the House Code on the Transceiver Module is set to `A. ' If you have changed the House Code on the remote (see p. 19), check that it matches the House Code on the Transceiver Module. · Press the ON/OFF button on the front of the Transceiver to confirm it operates the equipment connected to it. 25 If the Transceiver Module works, but other Modules don't respond: · Check that the Module has the same House Code as the Transceiver Module. · Try plugging the Module into a different outlet. [. . . ]