User manual X10 VK74A

[. . . ] OWNER'S MANUAL XM14A POWER SUPPLY C1 CAM ERA C2 C3 C4 P1 POSITION P2 P3 Cente r P4 Sweep CAMERA (SOLD SEPARATELY) M . O . K . A . C . . E . I. G SCAN Normal Pro gra m CR14A REMOTE ZC15A PAN 'N TILT BASE MODEL VK74A PAN 'N TILT CAMERA SYSTEM INCLUDES ZC15A PAN 'N TILT BASE, XM14A ADDRESSABLE POWER SUPPLY, CR14A REMOTE (CAMERA SOLD SEPARATELY) INTRODUCTION The VK74A includes the ZC15A Pan `n Tilt Camera Base with XM14A remote controlled power supply, and the CR14A remote control. You attach any XCam2 wireless camera (XX11A or XX13A) or any XCam 2 Instant On Camera (XX16A or XX17A) to the Pan `n Tilt Camera Base and then you can remotely control the camera's position using a CR14A remote control. The camera sends the picture and sound to a Receiver that you connect to your TV, up to 100 ft. [. . . ] To store the first position for the camera, press the BLUE buttons to scan to the position you want. Move the switch at the bottom from Normal to Program. To store the second position for the camera, press the BLUE buttons to scan to the position you want. Move the switch at the bottom from Normal to Program. To store the third position for the camera, press the BLUE buttons to scan to the position you want. Move the switch at the bottom from Normal to Program. To store the fourth position for the camera, press the BLUE buttons to scan to the position you want. Move the switch at the bottom from Normal to Program. To clear all stored positions: Move the switch at the bottom to Program. To store the fourth position for the camera controlled by C1. Press the BLUE buttons to scan to the position you want. Press C2 and repeat steps 2 to 7 above to store 4 positions for Camera C2. To control up to 4 Cameras, plug each one into its own Addressable Power Supply, and set each power supply to the same Housecode you set on the Transceiver and the Remote. Set each power supply to a unique number between 1 and 4. Pressing any Camera button (C1, C2, C3, or C4) turns on that camera (1, 2, 3, or 4) and turns the others (in the group) off. Then, each press of either the or button turns on the next or previous camera in the group of 4 while turning the current camera off. You must set all cameras to the same channel as the Video Receiver VR31A, or VR36A (Channel A, B, C, D). To "Pan" or "Tilt" a camera: Press C1, C2, C3, or C4 to turn on the camera. Then press a left or right BLUE button at the top to "Pan" the camera left or right. Press a BLUE up or down button to "Tilt" the camera up or down. Press C3 and repeat steps 2 to 7 above to store 4 positions for Camera C3. Press C4 and repeat steps 2 to 7 above to store 4 positions for Camera C4. [. . . ] To cancel the above automatic centering: While the camera is recentering, move the switch on the CR14A remote to Program, press Sweep, and then move the switch back to Normal. To stop the camera from ever recentering automatically: Unplug the camera's power supply, plug it back in, and (within 3 seconds) press Center. If the camera was sweeping when you unplugged it, it will continue to sweep when you plug it back in, so you should press any blue key to stop the sweep before you unplug the Camera. If the image quality changes as the Ninja base rotates: Since the Ninja rotates the camera, some positions may move the camera's antenna away from the direction of the Video Receiver. [. . . ]