User manual X10 VT32A

[. . . ] It has been type tested and found to comply with the limits for remote control devices in accordance with the specifications in Sub-Parts B and C of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by unplugging the equipment, try to correct the interference by one or more of the following measures. · Reorient the antenna of the radio/TV experiencing the interference. [. . . ] b) Connections for a TV without A/V OUT jacks. Just hook up the Video Sender using only the red and white jacks for the right and left channels of the audio signal. Leave the yellow (video) jack unconnected. 4 5 THE REMOTE EXTENDER FEATURE If you get a picture but the quality is poor: The Remote Extender feature allows X10 universal remotes to control some models of RCA DBS Receivers from another room. For example, you can change channels on your Satellite Receiver while viewing in another room. To use the Remote Extender Function you need to use the included Remote Extender Cable. Connect this cable to the IR jack on the Video Sender. Connect the other end of the cable to the IR Control input on the RCA DBS Receiver (DBS II or later model). Point the small tubular antenna on the Video Sender up. To operate the controls on the RCA DBS Satellite Receiver from another room, just press the appropriate buttons on the remote (in SAT mode). The remote sends RF signals directly to the Video Sender, even through walls. The Video Sender passes these signals through the Remote Extender cable to the RCA DBS Satellite Receiver. Try different positions for the antennas on the Sender and Receiver. The system usually works best with the flat side of the antennas facing each other (see diagram below). Sometimes, however, reflections and other effects in the home might affect the signal so that some adjustment of either the Sender or Receiver antenna may be necessary to get the best the signal. Point antennas at each other TROUBLESHOOTING If you do not see a picture on your TV: Check that the Sender and the Receiver are on the same letter channel (A, B, C, or D). The channel switches are on the bottom of the units. There is a power light on the front of each unit. Check that the power switch on the side of each unit is ON. Verify that your connections to the TV are correct. If you are using the RCA jacks, make sure you are using the appropriate input mode for your TV, try pressing the A-B button or Video button on your TV's remote control to change the input mode (consult your TV's owner's manual, if necessary). If you are using the COAX cable, verify that the Receiver and the TV are on the same channel (3 or 4). If you connected the Receiver to a VCR and then connected the VCR to your TV, you might need to turn the VCR OFF to see the picture on your TV. [. . . ] RETURN THE DEFECTIVE UNIT POSTAGE PREPAID TO THE ADDRESS BELOW 3. ENCLOSE A CHECK FOR $4. 00 TO COVER HANDLING AND RETURN POSTAGE. X10 IS NOT RESPONSIBLE FOR SHIPPING DAMAGE. UNITS TO BE RETURNED SHOULD BE PACKED CAREFULLY. [. . . ]