User manual XACT VISOR XS051 INSTRUCTION MANUAL

[. . . ] Such modifications could void the user's authority to operate the equipment. Use only the appropriate XACT accessories or input devices with your receiver. Use only the 12v Vehicle Adapter that is provided with the kit. It is important that you do not modify it in any way since this will result in damaging your equipment and void the warranty. COPYRIGHT / TRADEMARKS No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, whether electronic, mechanical, photocopying, recording or otherwise without the prior writing of the publisher. [. . . ] The device must be directly in line-of-sight of the remote controller. If you're not going to operate your vehicle for an extended period of time (e. g. parking garage while on vacation) unplug your XACT Visor Sirius Satellite Radio Receiver from the the cigarette lighter adapter. NOTE!Do not modify or alter in any way the wires or connections especially to the 12v vehicle adapter. Doing so will prevent the protection provided in the circuitry from functioning properly and result in damaging your receiver. This will void your warranty. 5 6 VEHICLE KIT INSTALLATION Mounting to the Dashboard or Console NOTE!Use only the appropriate XACT accessories or input devices with your receiver. Use only the 12v Vehicle Adapter that is provided with the kit. It is important that you do not modify it in any way since this will result in damaging your equipment and void the warranty. If using the AMPs mounting holes to fasten the Visor Vehicle Mount to your vehicle, Bolt or screw the Visor Vehicle Mount in place and proceed to step 3. Remove the protective film from one side of the supplied double sided 3M tape. Press firmly to secure the tape to the bottom of the Visor Vehicle Mount. Remove the protective film from the remaining side of the double sided 3M tape. Place the mount in the appropriate location on the vehicle's dash or console and press firmly. Slide the XACT Visor Satellite Radio Receiver onto the mounting tab of the Visor Vehicle Mount until it locks into place. To remove the XACT Visor Sirius Satellite Radio Receiver, push the locking tab on the bottom of the Visor inward and slide forward. Connect the DC Power, antenna and audio (if required) to the appropriate jacks. (figure 4). 1. 2. 3. 4. 6 INSTALLATION Mounting to the Windshield NOTE!Use only the appropriate XACT accessories or input devices with your receiver. Use only the 12v Vehicle Adapter that is provided with the kit. It is important that you do not modify it in any way since this will result in damaging your equipment and void the warranty. Insert the 4 suction cups into the larger side of the holes on the Visor Vehicle Mounting Bracket and slide outward to lock in place. Loosen the thumb screw and rotate the Visor Mounting tab to the appropriate angle for your vehicle's windshield. [. . . ] When no antenna is detected and the signal is lost, the flashing message "No Antenna" is displayed until an antenna is detected and the signal is acquired. Reception is weak or the audio has static and is unclear. Change the location of the Antenna making sure it is away from obstructions. 10 11 WARRANTY Warranty Information XACT Communication One-Year Limited Warranty This limited warranty sets forth all XACT Communication responsibilities regarding your product. There are no other expressed or implied warranties from XACT Communication. Warranty Service Provided If you purchased the product new from a retail vendor, XACT Communication warrants the equipment against defects in material and workmanship for a period of one (1) year from the original date of purchase. [. . . ]