User manual XEROX 495

[. . . ] Xerox 495 Continuous Feed Duplex Printer Operator Guide January 2007 708P88702 Prepared and translated by: Xerox, GKLS European Operations, WELWYN GARDEN CITY, AL7 1BU United Kingdom ©2007 by Xerox Corporation. Xerox® and all the products mentioned in this publication are trademarks of Xerox Corporation and Xerox Limited. Products and trademarks of other companies are also acknowledged. Copyright protection claimed includes all forms and matters of copyrightable material and information now allowed by statutory or judicial law or hereinafter granted, including without limitation, material generated from the software programs which are displayed on the screen such as icons, screen display looks, etc. [. . . ] DO NOT use hot water or dry cleaning as this may make the mark permanent. To replace the toner collector, proceed as follows: 1. Press the button to switch to the consumables view which shows the usage of all consumables and press the Change button beside Toner Collector. The consumables replacement screen for the toner collector will be displayed. Open the waste toner collector door at the rear of the printer. Hold both sides of the toner collector and pull the collector towards you. Page 8-24 Xerox 495 Continuous Feed Duplex Printer Operator Guide PERFORMING ROUTINE MAINTENANCE REPLACING THE TONER COLLECTOR 4. Slide the lid of the toner collector to close. Lid 5. Discard the toner collector using the attached vinyl bag. Slide the lid of the new toner collector to open. Lid 7. Attach the new toner collector by sliding it slowly into place. Note: Whenever you replenish the toner, keep the empty toner cassette to use as a toner collector. Press the button on the right of the touch screen to confirm the change and to return to the consumables view. Xerox 495 Continuous Feed Duplex Printer Operator Guide Page 8-25 REPLACING THE SMOKE FILTER PERFORMING ROUTINE MAINTENANCE Replacing the smoke filter The smoke filter must be replaced when Error Code 0B-01 is displayed. To replace the smoke filter, proceed as follows: 1. Press the button to switch to the consumables view which shows the usage of all consumables and press the Change button beside Smoke Filter. The consumables replacement screen for the smoke filter will be displayed. Open the smoke filter door. Handle Smoke Filter Door 4. Hold the handle of the smoke filter and pull forward to extract it. Insert a new smoke filter with the face up. Close the smoke filter door and the left stacker door. Press the button on the right of the touch screen to confirm the change and to return to the consumables view. Page 8-26 Xerox 495 Continuous Feed Duplex Printer Operator Guide PERFORMING ROUTINE MAINTENANCE CLEANING THE MACHINE Cleaning the machine Three areas of the machine should be cleaned on a regular basis. These are: · · · The fuser glass (front and back). The touch screen. The fuser glass (front and back) The fuser glass should be cleaned periodically because poor fusing or dirty background may occur if the glass is dirty. In addition toner particles may adhere to the glass during printing. [. . . ] The fusing unit fuses the image using flash fusing. The photoconductor drum surface is cleaned after transfer. Then the photoconductor drum is uniformly precharged for the next exposure. The waste toner after cleaning is recovered by the collection system. [. . . ]