User manual XEROX COLORQUBE 9201 9202 9203 APUVÄLINEIDEN VALIKKOKARTTA

[. . . ] Changes are periodically made to this document. Changes, technical inaccuracies, and typographic errors will be corrected in subsequent editions. Document version 1. 0: December 2012 Table of Contents 1 Introduction Smart Card Feature Overview . . 8 2 3 Preparation Configuration Checklist . [. . . ] If the certificate is encrypted, enter the password at the Password Required screen. Note: Both RootCA and Intermediate CA certificates need to be imported to the MFD to establish a ‘Chain of Trust’ for the certificates located on the operator’s smart card. Proceed to Configure SSL on page 24 Xerox® Smart Card Installation and Configuration Guide 23 Installation Install a Domain Controller Certificate 7. Complete these steps if you want to install a domain controller certificate. In the Properties tab select the Security link. Select Certificates > Security Certificates. Select the Domain Controller Certificates tab. Click Install Domain Controller Certificate. Click the Browse button and navigate to the location of your Domain Controller certificates. Continue until all required certificates have been uploaded. Configure SSL 8. SSL is used to provide a secure connection between your computer and the MFD when security certificates are configured on the MFD. This section requires you to configure LDAP and SMTP server information. If you do not want to configure Acquiring Logged-In User’s E-mail Address settings, proceed to Confirm the Installation on page 35. In the Properties tab, select the Login/Permissions/Accounting link. Select Acquiring Logged In User’s Address - Edit. d. e. f. Select the required option for Acquire logged in user’s e-mail address. If you select Auto or Only Network Address Book (LDAP), click Network Address Book (LDAP) - Edit to configure LDAP server settings. Click Add New. 26 Xerox® Smart Card Installation and Configuration Guide Installation At the LDAP Server screen, enter a Friendly Name. Enter the IP address or Host Name of the Primary and Alternate LDAP server. Select the required LDAP Server from the drop-down list. This is typically related to the server’s domain name. For example, if the server’s Fully Qualified Domain Name is ‘Hostname. Example. Search. Root’, the search directory root is “dc=Example, dc=Search, dc=Root”. Enter the required Login Credentials to Access LDAP Server. [. . . ] • Check the cable is plugged in correctly. Refer to Connect the card reader to the Xerox device on page 17 for instructions. • Unplug the card reader cable then plug back in. • Plug the card reader into a different USB port. [. . . ]