User manual XEROX PROCESS MANAGER FREEFLOW® & REMOTE CLIENTS 9.0 SERVICE PACK 9

[. . . ] Press the Clear All (AC) button to cancel any previous screen programming selections. Press the Services Home button on the Control Panel. Select the Fax button on the touch screen. This is usually the active tab when the Fax service opens. [. . . ] If required, select the Internet Fax tab. This is usually the active tab when the Internet Fax service opens. Use the touch screen keyboard to enter the e-mail address of the recipient. If you want to send the document to more than one recipient enter the additional details, one recipient at a time, and select the Add button again until all the recipients have been added. Select the Close button to save the information you entered. 2. 8. 9. For more information Please refer to: user guides - available via http://www. support. xerox. com 10. Press the Start button on the Control Panel to scan the original. ©2012 Xerox Corporation. XEROX®, XEROX and Design® are trademarks of Xerox Corporation in the U. S. IG120003 Xerox® WorkCentre™ 5845/5855/5865/5875/5890 How to Send an E-mail Control panel 3 1 5 6 2 4 1 2 Services Home Job Status 3 4 Touch Screen Start Document glass option 5 6 Clear All Stop Document feeder option OR 1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch the documents OR lift up the document feeder. Place the document face down onto the document glass and register it to the arrow at the top left corner. From most applications select the OK or Print button. For more information Please refer to: user guides - available via http://www. support. xerox. com ©2012 Xerox Corporation. XEROX®, XEROX and Design® are trademarks of Xerox Corporation in the U. S. IG120003 Xerox® WorkCentre™ 5845/5855/5865/5875/5890 How to Scan to Your Network Control panel 3 1 5 6 2 4 1 2 Services Home Job Status 3 4 Touch Screen Start Document glass option 5 6 Clear All Stop Document feeder option OR 1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch the documents OR lift up the document feeder. Place the document face down onto the document glass and register it to the arrow at the top left corner. Press the Clear All (AC) button to cancel any previous screen programing selections. Press the Services Home button on the Control Panel. Select the Workflow Scanning button on the touch screen. If required, select the Workflow Scanning tab. This is usually the active tab when the Workflow Scanning service opens. Select a template type from the All Templates dropdown menu. [. . . ] If the settings are correct select the Confirm button. If the settings are not correct change the settings as required. Tray 6 1. Media must be positioned against the left side of the tray. Paper must not be loaded above the maximum fill line. [. . . ]