User manual XEROX WORKCENTRE 5665 5675 5687 USB CARD READER PLUGIN INSTALLATION GUIDE

[. . . ] Changes are periodically made to this document. Changes, technical inaccuracies, and typographic errors will be corrected in subsequent editions. Document version 1. 0: July 2011 Table of Contents 1 Introduction Compatibility . . 8 2 Preparation Server Specifications . [. . . ] Select Authentication in the Directory Tree. In the Setup section, select Require Network Authentication. In the Authentication Type option select CAC/PIV (Common Access Card/Personal Identity Verification). In the Timeout option enter the number of minutes the system waits before logging out the user. Xerox Common Access Card Common Access Card Installation Guide 2. 3. 12 Installation 4. In the Feature Coverage option, select if a CAC card is required for Scanning Features Only (network scanning, Server fax and email) or for All Features (copy, print, scan, email). In the PIV Auth Mode option, select Prefer PIV or Prefer CAC depending on what type of cards are utilized in your environment. Add your LDAP server for authentication purposes with your PIV/CAC card. Select the type of server for authentication (for example Windows 2003, Windows 2008). Enter the IP Address or enter the Domain Controller Host name (this must be the fully qualified Host Name). Ensure Port 88 is selected, unless your Kerberos Port is different. Enter the Domain Name (this must also be the fully qualified Domain Name). If you wish to validate the DC against an OCSP server, select the Certificate validation via OCSP checkbox and enter the OCSP Server Service URL details. The Authentication Required window may be displayed on the touch screen, depending on your device configuration. Use the touch screen and numeric keypad to enter your PIN and then select Enter. If the card and PIN are authenticated, access is granted. Note: If the access attempt fails, refer to Troubleshooting Tips on page 25. To end the session, remove your card from the card reader. The current session is terminated and the Authentication Required window is displayed. Xerox Common Access Card Common Access Card Installation Guide 21 Installation 22 Xerox Common Access Card Common Access Card Installation Guide Troubleshooting 4 For optimal performance from your card reader, ensure the following guidelines are followed: · The Card Reader is only compatible with network connected products. · Ensure the Card Reader is plugged into the Network Controller. Refer to Connect the card reader to the Xerox device on page 20 for instructions. · Do not position the Card Reader in direct sunlight or near a heat source such as a radiator. · Ensure the Card Reader does not get contaminated with dust and debris. Xerox Common Access Card Common Access Card Installation Guide 23 Troubleshooting Fault Clearance When a fault occurs, a message displays on the User Interface which provides information relating to the fault. If a fault cannot be resolved by following the instructions provided, refer to Troubleshooting Tips on page 25. [. . . ] · Contact your System Administrator. · Check the IP Address printed on the configuration report. Ensure the DHCP settings match your site settings. · To print a configuration report at the Xerox device, select Machine Status, then Information Pages. [. . . ]