User manual XEROX WORKCENTRE 5845 5855 SMART CARD INSTALLATION AND CONFIGURATION GUIDE

[. . . ] Changes are periodically made to this document. Changes, technical inaccuracies, and typographic errors will be corrected in subsequent editions. Document version 7. 0: September 2011 Table of Contents 1 Introduction Compatibility . . 8 2 Preparation Server Specifications . [. . . ] This field will be missing if it is not required to upload the Domain Controller Certificate. At the Domain Controller Certificate option select Add and browse to the Domain Controller Certificate. Note: If you are unable to obtain the required certificates, refer to Retrieving the Certificate from a Domain Controller or OCSP Server on page 39. Select the Certificate then select Upload Domain Controller Certificate. 18 Xerox® Smart Card Installation Guide Installation If the Domain Controller certificate is not available, the certificate that was used to issue the Domain Controller certificate can be uploaded instead. The Domain Controller certificate, or its issuing certificate is needed by the device to validate the interactions between the device and the domain controller. Repeat the process to enter the details for all Domain Controllers. If an error is made, select the Domain Controller from the list, and make any corrections. Note: To change the Domain Controller search order, select the controller and use the up and down arrows on the right side of the screen to promote or demote the controller order. Upload certificates Note: These steps are Read Only if using any of the OCSP Certificate Validation options. Load the DC root and intermediate certificates and the OCSP root and intermediate certificates: a. Select the Link to Security > Trusted Certificate Authorities Page option or select Trusted Certificate Authorities from the menu. In the related services table on the Authentication Setup page, click Edit. . . The domain certificate on a Smart Card of a user must be validated on the domain controller server before they can access the printer. Under Domain Controller Type, select Windows Based Domain Controller if you are using one. Type the domain controller server address information. Click Save to apply the new settings or Cancel to return to the previous screen. If you have added more that one domain controller server, you can prioritize the alternate servers. On the Change Domain Priority page, select a domain controller in the list. Click the Up Arrow or Down Arrow to change the search priority of the server. Click Close. Xerox® Smart Card Installation Guide 21 2. 7. Installation 8. 9. To configure NTP settings, under Action, click Edit. . . The domain controller time and the time set on the printer must be synchronized. [. . . ] · Verify that Network Time Protocol is properly set up. · Verify that GMT offset is correct for your region, refer to Configure the date and time to update automatically on page 13. · Verify that GMT offset is correct for Daylight Savings Time. · Contact your System Administrator. [. . . ]