User manual XEROX WORKCENTRE XD120F

[. . . ] User Guide W orkCentre XD Series 701P33177 FCC Compliance in the USA WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Transparencies: removable stripe face up and toward the rear, one at a time. · Use labels, transparencies, and envelopes specifically designed for copiers (high temperatures). Place the original face down and align it with the registration guide on the document glass. Lower the alternate paper tray, located on the right side of the copier. Unfold the paper support extension as shown. Adjust the guides to the width of the copy paper. 5. Insert the copy paper all the way into the alternate paper tray until it stops (do not force). Note: When loading envelopes, labels, or transparencies insert one at a time. Press the Paper Supply button to select the alternate paper tray. 25 Two-Sided Copying (for all models except the XD130df/155df) 1. Place side 1 original face down on the Document Glass, with the TOP toward the LEFT. Note: 16 lb / 60 gsm copy paper is not recommended for two-sided copying. Remove the first original and place the second original face down on the Document Glass with the TOP toward the RIGHT, and lower the document cover. Remove the side 1 copies from the output tray and insert one of the copies face up, TOP toward the RIGHT, into the paper tray bypass. Continue feeding the Side 1 copies until all the two sided copies are made. Remove the Side 1 copies from the output tray and insert the copies face up, TOP toward the RIGHT, into the alternate paper tray. Press Start. xoreX xoreX 1 1 Xerox xoreX 1 2 26 Envelopes Various types and sizes of envelopes can be printed/copied on the WorkCentre XD using the bypass tray or alternate paper tray. Selecting Envelopes The construction of envelopes is critical to printing performance and varies widely. Use high-quality envelopes that are thin and sharply creased. Test a few envelopes before you purchase large quantities. Sizes: Minimum: 3 x 5" / 76 x 127mm Maximum 8. 5 x 14" / 216 x 356mm Hints: Try to avoid printing over the area where the envelope's three back flaps meet. Load one envelope at a time into the paper tray bypass or alternate paper tray. · · Make sure that the leading edge of the envelope is straight and firmly creased. [. . . ] If using Windows 95, the spool setting may be set incorrectly. Point to the Start Task bar and then click Settings then Printers. Click the Xerox Document WorkCentre XD with the right mouse button. Click Properties and then spool settings on the details tab. [. . . ]