User manual XINDAK XA8800MNE

[. . . ] Pass them on to possible new owners of the appliance. To allow adequate ventilation and to avoid overheating of the surrounding surfaces the hob should be positioned: Ventilation Positioning !Keep all packaging materials out of the reach of children. The appliance must be installed by a qualified professional in accordance with the instructions provided. [. . . ] The glue applied on the gaskets leaves traces of grease on the glass. Before using the appliance, we recommend you remove these with a special nonabrasive cleaning product. During the first few hours of use there may be a smell of rubber which will disappear very quickly. Electricity supply, all the lights and indicators on the control panel will switch on for a few seconds and a short buzzer will sound. It will be possible to switch on the hob only after the lights and indicators have switched off. switching on the extendable cooking zones • Double hotplate: 1. Press the button to switch on the smaller internal cooking zone. If the second cooking zone is circular: press the button to switch on (or off) the second cooking zone. If the cooking zone is oval: press the button. If the cooking zone is circular: Press the button to switch on (or off) the whole cooking zone (triple hotplate). A few seconds after the hob is connected to the Switching on the hob To switch the hob on, press and hold the for approximately one second. Repeat the above procedure for each hotplate you wish to programme. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will be switched on. The lights corresponding to the other hotplates programmed will flash. To display the time remaining for the other programmed hotplates, press the button repeatedly. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Press the button repeatedly until the time you wish to change is shown. Confirm by pressing the To cancel a programme, follow the above instructions. When it comes to point 2, press the buttons simultaneously. The setting will return to zero and the display will no longer be operating in the programme setting mode. “Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the “demo” mode the hob must be switched on, with the control panel lock activated. [. . . ] Stainless steel frame (only in models with outer frame) Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. After cleaning, it is advisable to rinse the surface well and dry it thoroughly. If water is spilt on the surface, dry it quickly and thoroughly. Some hobs have an aluminium frame which is similar to stainless steel. [. . . ]