User manual XSAT CD TV410

[. . . ] SUMMARY TABLE OF CONTENTS 1 - Important warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30/31 2 - Your digital receiver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32/35 3 - The remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36/37 4 - Using the remote control - Main menu . . . . . . . . . . . . . . . . . . . [. . . ] Use the graph supplied with your positioner to calculate the azimuth of one of your satellites. This depends on the latitude and longitude of the location. Press the Info key and indicate this value in tenths of a degree East or West. Press OK to preposition your motorised dish. Manually position your dish to obtain maximum reception levels and signal/noise ratio. Go to the "Adding a satellite" paragraph. MOTORISED DISH WITHOUT PREPOSITIONING Activate the "Go to position 0" command, to position your dish towards the south, or activate the "Scan with manual stop" command and position your motorised dish at "0" using the P P buttons (East or West). Position your dish in a southerly direction. Use a compass taking into account the magnetic drift of the location. Activate the "Go to preset position" command. Adjust the position of your dish using the movement buttons. When the signals are at maximum, validate the position with the OK button. "Scan with auto stop" mode can also be chosen. After pressing one of the P P buttons, the receiver stops the motor automatically as soon as there are satisfactories signal level and signal/noise ratio. ADDING A SATELLITE To adjust the position for another satellite, add it in the Antenna menu, and adjust the position in the "Positioning antenna" menu. When correctly positioned, press the OK button to memorise it. The "Recalculate" command can then be reactivated if your dish positioning system supports this command. All memorised satellite positions will be adjusted. 44 CHANNEL SCAN 7 Scan satellite Scanning mode Satellite Fast (NIT) ASTRA OK RET NIT parameters CHANNEL SCAN With the "Channel List/Scan satellite" menu, you can scan the available channels on selected satellite(s). Only the satellites defined on the configuration screen can be used. Three scan modes are available: - Fast (NIT) - Exhaustive - Frequency Use the buttons to select the mode. Fast scan (NIT) This is the fastest scan (normally less than two minutes for a complete satellite). It uses an information table broadcasted by the satellite in accordance with the DVB standard (NIT: Network Information Table). This table includes most of the programs available on the satellite. This method is quick and easy, although it can only find the services defined by the NIT. [. . . ] All the commands are sent by the master. DiSEqC Components If all the switch matrices are in series, the Master receiver must send the DiSEqC signal a number of times, so that all DiSEqC multiswitches receive commands in series. DiSEqC components (Slaves) have to be compatible downstream, which means that they must also meet receiver analogue switching criteria which only accept H/V and 22 kHz command signals. A DiSEqC switch matrix thus operates with analogue switch criteria until the master sends a DiSEqC command. [. . . ]