User manual XYRON 2500

[. . . ] Xyron recommends watching this video before attempting to load and use the 2500. Loading Supply Rolls Step 1: Step 2: · Remove the top cover of the machine by lifting upward. · Grasp the handle on the lower access door; pull to open. · Match the colored dots on the end of each supply roll with the corresponding dots on the side of the machine. Note which roll is identified as "top" and "bottom". grooves in the sides of the machine, making certain that the roll is inserted completely. · Slide the supply rolls into the EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 Step 3: Step 4: Step 5: · On the bottom supply roll, grasp the laminated starter section by the leading edge film. [. . . ] Use caution to avoid cutting into the rubber rollers. · Remove the feed tray by lifting and pulling away from the machine. · Slide the knife towards the right Step 3: Step 4: · Turn the handle 1/2 turn maximum in the direction of the arrows. This step will cause the uncut film at the edges to break, creating a laminated leader for easy installation at a later time. · Remove the supply rolls from the machine. Xyron recommends that supplies are stored laying flat in a cool, dry place using the original packaging. EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 Maintenance, Safeguards & Tips When properly used, the Xyron 2500 is relatively maintenance-free. Listed below are safeguards and tips that will produce better results. Refer to the exploded view diagram for part descriptions. Importance of a clean document: For best results when laminating, it is highly recommended that the document be cleaned with a soft, lint-free cloth immediately prior to lamination. Small dust or lint particles may cause the laminate to "tent", producing an appearance similar to a small air bubble. Cut blade replacement and cleaning: The cut blade may accumulate adhesive over time. Cleaning the blade must be done with great care to avoid personal injury. To remove the blade, slide the orange blade holder into the notch and lift upwards. Carefully remove the blade holder and replace or clean with a light solvent such as isopropyl alcohol. Use after storage: For applications where the appearance of your laminated document is critical, it is highly recommended that the Xyron 2500 be used and stored in a clean, dust-free environment. Airborne dust particles and lint will tend to adhere to the bare adhesive inside the supply roll. If the machine has not been used for several days or was subject to a dusty environment, it is recommended that four inches (10cm) of material be advanced and discarded before inserting your document. It is also recommended that the feed tray is cleaned with a lint-free cloth. Contact your dealer about a dust cover as an accessory. Cleaning adhesive from the nip rollers: The nip rollers are designed to be self-cleaning under normal use. If adhesive does accumulate, it can normally be removed by first removing the supply films from between the nip rollers and advancing a scrap piece of regular bond paper through the machine. The bare adhesive will tend to attach to the paper. If this method of cleaning does not work, the nip rollers can be cleaned with a light solvent such as isopropyl alcohol. [. . . ] Prior to loading document, pull paddle back to "load" position. Ensure underside of paddle is clear of any obstruction or adhesive buildup. Verify supply rolls are firmly seated at base of grooves in side plates. Clean adhesive buildup from idler roller using isopropyl alcohol or Xyron Adhesive Cleaner #990. Cut Blade does not slide smoothly. [. . . ]