User manual YAMAHA 03DVEK

[. . . ] 22 02R with Two ADATs (Timecode on Tape Track). 02R with Analog 16-Track Multitrack Recorder . 02R with Video Machine, ADAT, & BRC . 02R with Video Machine, ADAT, & AI-2 . [. . . ] Do not leave the screws out after installation as the cards will not be grounded correctly. · DA-88­A is connected to Slot [1] of the 02R and the tape inputs correspond to tracks one through eight (Tape In 1­8). DA-88­B is connected to Slot [2] of the 02R and the tape inputs correspond to tracks nine through sixteen (Tape In 9­16). DA-88­C is connected to Slot [3] of the 02R and the tape inputs correspond to tracks 17 through 24 (Line In 1­8). DA-88­D is connected to Slot [4] of the 02R and the tape inputs correspond to tracks 25 through 32 (Line In 9­16). · The optional SY-88 Sync Board is required for DA-88­A. This enables the dedicated timecode track, which can be re-striped at anytime, and provides SMPTE timecode and MTC outputs. A timecode offset can be specified on DA-88­A. 02R Wordclock Setup On the DIGITAL I/O menu, the wordclock source should be set to W. CLK. DA-88 Wordclock Setup DA-88­A works as wordclock master. Wordclock is fed to the 02R using a BNC to BNC cable, and to the other DA-88s using PW-88S 15-pin sync cables. The sampling rate is set when the DA-88 tapes are formatted. After formatting, the sampling rate is determined by the formatted tape. Notes · The DA-88s must be powered up even when they are not being used. DA-88­B is connected to Slot [2] of 02R­A and the tape inputs correspond to tracks nine through sixteen (Tape In 9­16). DA-88­C is connected to Slot [1] of 02R­B and the tape inputs correspond to tracks 17 through 24 (Tape In 1­8). DA-88­D is connected to Slot [2] of 02R­B and the tape inputs correspond to tracks 25 through 32 (Tape In 9­16). PW-88DL cables are available from Tascam. · The optional SY-88 Sync Board is required for DA-88­A. This enables the dedicated timecode track, which can be re-striped at anytime, and provides SMPTE timecode and MTC outputs. A timecode offset can be specified on DA-88­A. 02R Wordclock Setup On the DIGITAL I/O menu, the wordclock source should be set to W. CLK. DA-88 Wordclock Setup DA-88­A works as wordclock master. Wordclock is fed to the 02R using a BNC to BNC cable, and to the other DA-88s using PW-88S 15-pin sync cables, available from Tascam. The sampling rate is set when the DA-88 tapes are formatted. After formatting, the sampling rate is determined by the formatted tape. Notes · The DA-88s must be powered up even when they are not being used. Failure to do so may cause an intermittent pumping noise on the 02R. [. . . ] In addition, the 03DVEKVEK has a small footprint and can be rack-mounted. · A full assignment of inputs and outputs, including 18 analog inputs (16 mono/1 stereo) and 10 analog outputs (1 stereo, 4 bus, 4 aux). · Every input and output features a 4-band parametric EQ, dynamics processor, and delay, all of which can be stored in the libraries. · Scene memories store a snapshot of all mix settings and can be recalled in an instant. [. . . ]