User manual YAMAHA 115

[. . . ] If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA 90620 The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries. WARNING: THIS APPARATUS MUST BE EARTHED IMPORTANT THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE: GREEN-AND-YELLOW : BLUE : BROWN : EARTH NEUTRAL LIVE As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured GREEN and YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or coloured GREEN and YELLOW. The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. [. . . ] · Do not locate the power supply unit in a place subject to excessive heat or in direct sunlight. · Do not place the power supply unit in a place subject to excessive humidity or dust. This could be a fire and electrical shock hazard. · Do not allow water to enter this unit or allow the unit to become wet. · Do not plug several devices into the same AC outlet. This may overload the AC outlet, and could be a fire and electrical shock hazard. It may also affect the performance of some equipment. · Do not place heavy objects on the power cord. A damaged power cord is a potential fire and electrical shock hazard. · If the power cord is damaged (i. e. , cut or a bare wire is exposed), ask your dealer for a replacement. Using the power supply unit in this condition is a fire and shock hazard. Using the power supply unit in this condition is a fire and electrical shock hazard. · If you plan not to use the power supply unit for a long period of time, remove the power cord from the AC outlet. Leaving the power supply unit connected is a fire hazard. · Do not use benzene, thinner, cleaning detergent, or a chemical cloth to clean the power supply unit. · The power supply unit uses high-frequency digital circuits that may cause interference on radios and televisions placed close to it. If interference does occur, relocate the affected equipment. · The power supply unit is equipped with the ground connector to avoid the risk of electrical shock. Be sure to ground the unit before you insert the power plug into an AC outlet. If the power cord has three pins and the ground connector on the AC outlet is grounded, the unit will be grounded effectively. Operating Notes · The power must be turned on/off using the POWER switch of this unit. Do not turn the power on/off by plugging in the power cable, or by using a power strip or circuit breaker. · Do not rapidly turn on and off the POWER switch of this unit. [. . . ] To install the unit, please select a location with good ventilation. Do not block the front panel or rear panel or you may restrict fan air flow. Be sure to use the included special cable to connect the unit to the CS1D. Never use other cables to connect these units. s Front panel 1 POWER ON OFF s Rear panel 2 DC OUTPUT CONNECT 3 AC IN DISCON 4 A POWER ON/OFF switch and indicator After connecting the 115 to the CS1D using the included cable, turn this switch on to supply power to the CS1D. clockwise to connect the cable, and turn it counterclockwise to disconnect the cable. D Ground connector Be sure to ground the unit to avoid the risk of electrical shock before you insert the power plug into an AC outlet. [. . . ]