User manual YAMAHA 15HP-2004

[. . . ] 9. 9C 15C OWNER'S MANUAL U. S. A. Edition LIT-18626-05-34 E EMU01448 TO THE OWNER Thank you for choosing a Yamaha outboard motor. This Owner's manual contains information needed for proper operation, maintenance and care. A thorough understanding of these simple instructions will help you obtain maximum enjoyment from your new Yamaha. If you have any question about the operation or maintenance of your outboard motor, please consult a Yamaha dealer. [. . . ] 4-3 E q When transporting or storing the outboard motor while removed from a boat, fold the tiller handle and lean the motor on the tiller handle to keep in a horizontal position. 1 Vertical position 2 Horizontal position NOTE: Place a towel or the like under the outboard motor to protect it from damage. cC Keep the power unit higher than the propeller at all times. Otherwise, cooling water can run into the cylinder, which could result in damage. EMK22010** STORING OUTBOARD MOTOR 102015 w When storing your Yamaha outboard for prolonged periods of time, (2 months or longer), several important procedures must be performed to prevent expensive damage. It is advisable to have your outboard serviced by an authorized Yamaha dealer prior to storage. However, the following procedures can be performed by you, the owner, with a minimum of tools. Filling Fuel Tank Fill the fuel tank with fresh fuel and add one ounce of "Yamaha fuel conditioner and stabilizer" (Part No. NOTE: The use of Yamaha Fuel Conditioner and Stabilizer eliminates the need to drain the fuel system. Consult your Yamaha dealer or other qualified mechanic if the fuel system is to be drained instead. 4-4 102013 E EMU00338* Flushing Cooling System and Fogging Engine Cooling system flushing is essential to prevent the cooling system from clogging up with salt, sand, or dirt. In addition, fogging of the engine is mandatory to prevent expensive engine damage due to rust. Perform the flushing and fogging at the same time. w 8 Do not tough or remove electrical parts when starting or during operation. 8 Keep hands, hair and clothes away from flywheel and other rotating parts while engine is running. EMU00994* 8 Flushing in a Water Tank cC If the fresh water level is below the level of the anti-cavitation plate, or if the water supply is insufficient, engine seizure may occur. Install the outboard motor on the water tank. Fill the tank with fresh water to above the level of the anti-cavitation plate. Remove the cap a for fogging on the silencer cover. Run the engine at a fast idle for 10~15 minutes. Just prior to turning off the engine, quickly spray "Yamaha Stor-Rite Engine Fogging Oil" (Part No. LUBSTRRT-12-00) into the silencer cover. When properly done, the engine will smoke excessively and almost stall. Install the cap and the top cowling. 2 Lowest water level a 4) 5) 6) q w 7) 605024 8) 4-5 1 Water surface E EMK26010 Lubrication 1) Remove the spark plugs, and spray a 10 second spray of Yamaha Stor-Rite Engine Fogging Oil into each cylinder. Grease the spark plug threads and reinstall the spark plugs and torque to proper specification. (Refer to the Periodic Maintenance section, "Cleanning and adjusting spark plug. "). 2) Turn the engine over with the stop lanyard disconnected to work the fogging oil into the piston rings. [. . . ] WARRANTY DEPARTMENT P. O. Box 6555 Cypress, California 90630 This will ensure that Yamaha Motor Corporation, U. S. A. has an up-to-date registration record in accordance with federal law. EMU01178 IMPORTANT WARRANTY INFORMATION IF YOU USE YOUR YAMAHA OUTSIDE U. S. A. OR CANADA Welcome to the Yamaha Family!Congratulations on the purchase of your new Yamaha marine power. [. . . ]