User manual YAMAHA 20EH2 SERVICE MANUAL

[. . . ] The unit is equipped with four spikes, one in each of the front leg's rubber feet and two on the frame. Spikes located in the legs rubber feet can be extended by loosening the drum key bolt. Those in the frame can be extended to the preferred length by rotating the bolts clockwise. !0 The Supplied Soft Case and Sheet To protect the hi-hat stand's finish from scratches, etc. , werecommend that it be placed in the supplied soft case when transporting. [. . . ] Also, please wrap the upper pipe in the supplied sheet. Introduction Thank you for purchasing this Yamaha Hi-Hat Stand. In order to obtain maximum performance and longevity from hi-hat stand, please read this Owner's Manual thoroughly. Clutch Nut u Adjusting Leg Position The position of the legs (footboard) can be adjusted by loosening bolts A and B, shown in the diagram on the right. After the position has been determined, firmly tighten bolts A and B. Leg Drum Key Bolt q e Memory Clamp After you have determined the height of the hi-hat cymbal, secure the memory clamp at the base assembly's pipe holder to set a "memory" of the pipe's position for future settings. At this time, make sure the memory clamp fits into the pipe holder. Use a drum key to firmly tighten the memory clamp so as to prevent the pipe from slipping during performance. Also, the pipe holder is equipped with a drum key holder. Turning the dial to the left increases tension while turning to the right decreases tension. Also, this system is equipped with a tension indicator that conveniently displays the amount of tension. Angle Adjuster · HS1100 Hi-Hat Clutch Hi-Hat Shaft Fixing Nut Fixing Nut Knurled Head Bolt · HS1000 Hi-Hat Clutch · HS950 Hi-Hat Clutch Cymbal Support Plate Hi-Hat Shaft Cymbal Support Plate Hi-Hat Shaft Cymbal Support Plate Fixing Nut Knurled Head Bolt Cymbal Support Plate Knurled Head Bolt Fixing Nut Knurled Head Bolt Memory Clamp Memory Clamp Base Assembly Pipe Holder Bolt A Indicator Adjustment Dial Bolt A Indicator Adjustment Dial Angle Adjuster Bolt B Bolt B Memory Clamp Base Assembly Pipe Holder Bolt A Indicator Adjustment Dial Angle Adjuster Bolt B Footboard w Hi-Hat Clutch (LC-930) The top hi-hat cymbal is fixed and held in place between the two felts of the hi-hat clutch. Base Assembly Pipe Holder (Procedure) 1) Loosen the drum key bolt q on the clutch nut and remove the clutch nut from the clutch bolt. 2) Remove the lower felt and place the cymbal between the upper felt and the lower removed felt. 3) Firmly tighten the clutch nut onto the clutch bolt. Next, tighten the drum key bolt q to lock the clutch nut. Since the drum key bolt q can be locked with a minimum of force, be sure not to over tighten which may cause damage to the bolt. [. . . ] Next, tighten the drum key bolt q to lock the clutch nut. Since the drum key bolt q can be locked with a minimum of force, be sure not to over tighten which may cause damage to the bolt. 4) The lock nut adjusts the amount of pressure used to hold the cymbal in place. [. . . ]