User manual YAMAHA A4115H

[. . . ] Information The contents of this manual and the copyrights thereof are under exclusive ownership by Yamaha Corporation. The company names and product names in this manual are the trademarks or registered trademarks of their respective companies. Some functions and parameters in this manual may not be provided in your product. The information in this manual is current as of October 2010. EN Table Of Contents 1 Voice Parameters . [. . . ] If the resulting Velocity value is 0, it will be set to 1. If the resulting Velocity value is greater than 127 it will be set to 127. Gate Time Rate Determines how much the Gate Time (length) of the Arpeggio notes is offset from the original value. 100%: Indicates that the original Gate Times are used. Below 100%: Shortens the Gate Times of the Arpeggio notes. Above 100%: Lengthens the Gate Times of the Arpeggio notes. The Gate Time cannot be decreased beyond its normal minimum of 1; any values outside that range will automatically be limited to the minimum. Octave Range Specifies the maximum Arpeggio range in octaves. Positive values: Increase the Octave Range of the Arpeggio playback upwards. Negative values: Increase the Octave Range of the Arpeggio playback downwards. Determines whether the Arpeggio plays a single time or continuously, while notes are held. On: The Arpeggio cycles while notes are held. Off: The Arpeggio plays only once even if notes are held. The function settings for all controllers are referred to as a Controller Set, and several Controller Sets can be created for each Voice. The controller is referred to as Source, and the controlled function is referred to as Destination. Source Determines which panel controller is to be assigned and used for the selected Controller Set. You can assign multiple functions to a controller. Determines the parameter that is controlled by the Source. You can select any of the available parameters for each controller, such as volume, pitch and LFO depth. Determines the degree to which the Source affects the Destination parameter. For negative values, the controller operation is reversed: maximum controller settings produce minimum parameter changes. Determines whether or not the selected controller affects each individual Element of the current Voice. This parameter is disabled when the Destination is set to a parameter that is not related to the Voice Elements. Destination Depth Controller Set Element Switch 47 Voice Parameters 1-3-7 Effect The Effect unit applies Effects to the output of the tone generator block and audio input block, processing and enhancing the sound. Effects are applied in the final stages of editing, letting you change the sound of the created Voice as desired. The unprocessed sound is called "dry" sound, and the processed sound is referred to as "wet. " Master Effect System Effect Master effects are applied to the final stereo output signal of the entire sound. [. . . ] #123) However, if Hold1 or Sostenuto is on, notes will continue sounding until these are turned off. Omni Mode Off (Control #124) Omni Mode On (Control #125) Mono (Control #126) Performs the same operation as when an All Notes Off message is received. Performs the same operation as when an All Notes Off message is received. Only the receive channel is set to Omni On. [. . . ]