User manual YAMAHA AMP EDITOR

[. . . ] Amp Editor Version 1. 2 Owner's Manual EN What is Amp Editor? Amp Editor is software that allows network-compatible amplifiers (such as the TX4n/5n/6n), amp control devices (e. g. , the ACD1), and compatible amplifiers connected to amp control devices to be assembled into a system, monitored, and controlled from a computer. Amp Editor allows centralized monitoring and control of multiple connected devices. Special Notices The software and this manual are the exclusive copyrights of Yamaha Corporation. Use of the software and this manual is governed by the license agreement which the purchaser fully agrees to upon breaking the seal of the software packaging. (Please read carefully the Software Licensing Agreement at the beginning of Installation Guide before installing the application. ) Copying of the software or reproduction of this manual in whole or in part by any means is expressly forbidden without the written consent of the manufacturer. [. . . ] A new device will be added below the specified workspace. Copying settings You can copy the settings of an amplifier that is listed in the tree. You can select from two copy types: [All current parameters], which enables you to copy all settings other than those unique to the device, such as a Device ID; and [Selected parameters], which enables you to copy the selected settings. Copying "All current parameters" 1. 2. Right-click the icon of the amplifier whose settings you want to copy. From the context menu, choose [Copy][All current parameters]. All parameters other than those listed below will be copied. Scene, Device ID, device name, Utility settings, Log Setup, Global Link, Solo and MY-Card (TXn only) Amp Editor 102 Owner's Manual Chapter 6 Tree View window Copying "Selected parameters" 1. 2. Right-click the icon of the amplifier whose settings you want to copy. In the context menu, choose [Copy][Selected parameters]. The "Select Copy Item" dialog box will be displayed. 3. Selects the settings you wish to copy. If you select the [Scene] check box when the unit is offline, you will be able to select a scene as a copy source. 4. Click the [OK] button. The selected setting will be copied. Pasting settings You can paste the copied amplifier settings to another unit in the same series. 1. 3. Right-click the icon of the amplifier to which you want to paste the amplifier settings. Click the [OK] button on the confirmation dialog. The settings will be pasted to the destination amplifier. NOTE · You cannot paste the scene to the destination amplifier while the amplifier is online. Amp Editor 103 Owner's Manual Chapter 6 Tree View window Renaming (Rename Label) You can edit the name (label) of a device or workspace (with the exception of I/O cards). 1. 2. Right-click the icon of the item that you want to rename. From the context menu, choose [Rename Label]. The "Rename (Device) Label" dialog box will appear. NOTE · For items other than an amplifier, only Name can be edited. 3. 4. Enter the desired name in the text box such as "Device" and "Channel A. " Click the [OK] button. The name will be changed, and the dialog box will close. If you click the [Cancel] button, the dialog box will close without changing the name. Changing the Device ID (Change Device ID) You can change the Device ID of a device. 1. 2. Right-click the icon of the item whose ID you want to change. From the context menu, choose [Change Device ID]. [. . . ] The device or network switch is not powered-on. There are conflicting device IP addresses in the network. The most significant three digits of the computer's IP address do not match the most significant three digits of the device's IP address. You have confused the [NETWORK] connector and the [DATA PORT] connector for connection on the ACD1. [. . . ]