User manual YAMAHA AR230-2004

[. . . ] *AR230(SRT1000)-'04-OwnMnl 11/10/03 11:26 AM Page 2 Owner's / Operator's Manual AR230 Owner's / Operator's Manual LIT-18626-05-72 ©2003 Yamaha Motor Corporation, U. S. A. Printed in U. S. A. *AR230(SRT1000)-'04-OwnMnl 11/10/03 11:26 AM Page 4 TO THE OWNER Thank you for choosing a Yamaha Sport Boat. This Owner's Manual contains information you will need for proper operation, maintenance, and care. A thorough understanding of these simple instructions will help you to obtain maximum enjoyment from your new Yamaha. If you have any questions about the operation or maintenance of your Sport Boat, please consult a Yamaha dealer. [. . . ] Be sure it is securely tightened before launching the Sport Boat. 3-12 3-13 *AR230(SRT1000)-'04-OwnMnl 11/10/03 11:26 AM Page 3-14 3 OPERATION CAUTION: Never turn the ignition key to "Start" while the engine is running. Do not keep the starter motor running for more than 5 seconds. If the engine does not start after 5 seconds of cranking, release the starter button. Wait at least 15 seconds before trying to start the engine again. If the starter motor is engaged continuously for more than 5 seconds, the battery will be quickly discharged, and it will be impossible to start the engine. The starter motor may also be damaged if it is engaged continuously for more than 5 seconds. NOTE: Be sure the shift lever is put in the Neutral position or the starter motor will not operate. On this boat, the engines are connected directly to the drive unit. Starting either engine generates some thrust immediately. Only enough throttle should be applied to keep the engine at a fast enough idle to stay running. PW V V OPERATION STOPPING THE ENGINES CD T T FM 3 ON JVC AM 3 5 4 6 OFF ctronics pec Ele By Pros STAR ON START OFF 2 1 NOTE: Before the first start-up, remove the fuel tank filler cap to release any built-up pressure in the tank because of fuel expansion. 1 1 2 Engine shut-off switch Clip with cord NOTE: It is not possible to start the engine with the clip removed from the engine shut-off switch. However, the starter motor will turn the engine over. PW V V CD T T To stop the engine, return the throttle levers to the idle position, then turn the main switches to "Off. " The engines can also be stopped by pulling the engine stop switch lanyard. WARNING Once the engine has stopped, you have NO STEERING CONTROL over the boat. You could collide with another boat, a dock, or other obstacle. NOTE: Remove the ignition keys and the engine stop switch lanyard if the boat will be left unattended. Stopping the engines immediately after operating at high rpm is not recommended. Let the engines cool off at idle or low speed for a few minutes first. JVC AM 3 5 4 6 ON ctronics pec Ele By Pros OFF STA ON START OFF 2) Attach the engine shut-off cord to your PFD. Install the cord clip onto the engine shut-off switch by pushing the clip groove over the nut beneath the knob. Be sure the cord is not wrapped around the steering wheel or tangled in the controls. CAUTION: 3) Put the control levers in the Neutral position. Turn the ignition key of one engine to "Start. " When the engine starts, release the key. Do not operate the Sport Boat with just one engine running. Severe engine damage could result because water can flood the nonoperating engine through the cooling water intake. If single-engine operation is unavoidable, operate the boat at a "no wake" speed only. 3-14 3-15 *AR230(SRT1000)-'04-OwnMnl 11/10/03 11:26 AM Page 3-16 3 OPERATION DRIVING YOUR SPORT BOAT GETTING TO KNOW YOUR SPORT BOAT Operating your Sport Boat requires skills acquired through practice over a period of time. Take the time to learn the basic techniques well before attempting more difficult maneuvers. [. . . ] 1-15 Rules when encountering other vessels . 2-6 Meeting other vessels (Rules of the Road) . 1-9, 1-17, 3-10 Hull Identification Number . 1-1 S O Obtaining repairs under warranty . [. . . ]