User manual YAMAHA AVP007

[. . . ] After reading this Owner’s Manual, ensure that it is kept in a safe, convenient location for future reference. Always follow the basic precautions listed below to avoid the possibility of physical injury to you or others, or damage to the instrument or other property. These precautions include, but are not limited to, the following: CAUTION • Do not place the product in an unstable position where it might accidentally fall over. € If this product is used with a Rack System or Cymbal Stand, make sure all bolts are tightened firmly. [. . . ] € Please be careful when children are close to or touching the product. Careless movement around the product may result in injury. € When setting the product, please pay close attention to the handling and setting of cables. Carelessly placed cables may cause the user and others to trip and fall. Doing so may result in injury or damage/deterioration to the product. NOTICE • Do not step on or place heavy objects on the product. € Do not use or keep the product in places with extremely high temperature (places in direct sunlight, close to a heater, in a closed car, etc. ) or high humidity (bathroom, outside on a rainy day, etc. Doing so may result in deformation, discoloration, damage or deterioration. € Never leave any materials which are easily color-transferable, such as rubber items, on the drum pad surface. Otherwise, the color of the material may be transferred to the drum pad surface. Slide the stopper onto the cymbal holder. ) If the key bolt was not sufficiently loosened in Step 1 above, it may not be possible to slide the stopper onto the cymbal holder’s shaft. In such a case, loosen the key bolt as much as possible without removing it. ) When assembling the bolt cover, turn it until it stops. With the stopper making full contact with the bottom surface of the bolt cover, tighten the stopper’s key bolt using the tuning key. Place one of the felt pads removed in Step 2 on the cymbal holder. Lower the pad into place with the cymbal holder’s shaft passing through the hole at the center of the cup. When mounted, the stopper’s pin should rest inside the pad’s smaller hole. ) If the stopper’s pin is not positioned fully inside the smaller hole, the pad could become free of the stopper when played. It is very important, therefore, to ensure that the stopper is secured as described in Step 5 above. Place the second felt pad removed in Step 2 on the cymbal holder. [. . . ] ) Wing nut Stopper Cup Pad Smaller hole Felt pad Pad Cup Felt pad Bolt cover Pin Cymbal holder Stopper Figure 5 Pads and Trigger Input Jacks The functions that the pad can perform will depend on which of your drum module’s trigger input jacks it is connected to. A chart showing the correspondence between pad functionality and input jack types can be accessed via the web page shown below. Com/ 8 AVP007 Owner’s Manual Connecting Using the stereo audio cable provided, connect the cymbal pad’s output to a suitable input jack on your DTX series drum module. At this time, ensure that the L-shaped end of the cable is plugged into the pad’s [OUTPUT] jack. [. . . ]