User manual YAMAHA AX-400

[. . . ] 10 Notes about the Remote Control Transmitter . . . . . . . . . . . . . . . . . 11 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . 12 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . Please record the serial number of this unit in the space below. · Explanation of Graphical Symbols Model: Serial No. : The serial number is located on the rear of the unit. [. . . ] If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Electronics Corp. , U. S. A. 6660 Orangethorpe Ave, Buena Park, CA 90620. The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries. We Want You Listening For A Lifetime YAMAHA and the Electronic Industries Association's Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level. One that lets the sound come through loud and clear without annoying blaring or distortion ­ and, most importantly, without affecting your sensitive hearing. Since hearing damage from loud sounds is often undetectable until it is too late, YAMAHA and the Electronic Industries Association's Consumer Electronics Group recommend you to avoid prolonged exposure from excessive volume levels. SUPPLIED ACCESSORIES After unpacking, check that the following parts are contained. q Remote Control Transmitter q Batteries (size AA, R6, UM-3) PLAY/CUT PHONO POWER SKIP PLAY CD SEARCH PAUSE/STOP DISC SKIP ­ PRESET + A/B/C/D/E TUNER DIR A DECK A/B DIR B TAPE 1 PLAY TAPE 2 REC/PAUSE STOP REC MUTE PRESET SKIP ON/FLAT EQ ­ VOLUME AUX + 3 CONNECTIONS q q Before attempting to make any connections to or from this unit, be sure to first switch OFF the power to this unit and to any other components to which connections are being made. When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left) to L, R (right) to R, "+" to "+" and "­" to "­". Also, refer to the owner's manual for each component to be connected to this unit. Turntable Tuner Compact disc player Speakers A OUTPUT OUTPUT Right Left OUTPUT REMOTE CONTROL GND (U. S. A. model) To AC outlet AUDIO OUT LINE OUT LINE IN LINE OUT LINE IN Right Tape deck 1 Video cassette player, LD player, etc. Tape deck 2 Speakers B Left Illustration: AX-570 Parts in shaded area ( ) are not present on AX-400. 4 ENGLISH CONNECTING SPEAKERS Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. On each key function, refer to the corresponding instruction on your component's manual. Controls tuner +: Selects higher preset station number. ­: Selects lower preset station number. A/B/C/D/E: Selects the page (A ­ E) of preset station buttons. PLAY/CUT PHONO POWER SKIP PLAY CD Starts/stops record play on turntable. Controls compact disc player. * DISC SKIP is applicable only to compact disc changer. SEARCH PAUSE/STOP DISC SKIP ­ PRESET + A/B/C/D/E TUNER DIR A DECK A/B DIR B TAPE 1 Controls equalizer. * PRESET SKIP selects any preset equalizer curve whenever this is pressed. (After the last preset curve is selected, it returns to the first one by another press on this key. ) PLAY TAPE 2 REC/PAUSE STOP REC MUTE PRESET SKIP ON/FLAT EQ ­ VOLUME AUX Controls tape deck. * DIR A, B and DECK A/B are applicable only to double cassette tape deck. * For a single cassette deck with automatic reverse function, pressing DIR A will reverse the direction of tape running. + 10 ENGLISH STANDBY mode <For AX-400 and Europe model of AX-570> While the power is on, pressing the POWER key on the remote control transmitter switches the unit to the STANDBY mode. (In this mode, the indicator is half illuminated. ) Note The POWER switch on the front panel of this unit should be turned off when left unused for a long period of time. <AX-400> POWER on mode STANDBY mode <Europe model of AX-570> POWER on mode STANDBY mode NOTES ABOUT THE REMOTE CONTROL TRANSMITTER Battery installation 1 Remote control transmitter operation range 3 2 Remote control sensor Within approximately 7 m (23 feet) Battery replacement If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Notes q Use only AA, R6, UM-3 batteries for replacement. (See the illustration inside the battery compartment. ) q Remove the batteries if the remote control transmitter will not be used for an extended period of time. [. . . ] The distance or range within which the remote control transmitter can be used decreases. The PURE DIRECT switch is ON. Direct sunlight or lighting (of an inverter type of flourescent lamp etc. ) is striking the remote control sensor of the main unit. The batteries of this remote control transmitter are too weak. Change position of the main unit. Replace the batteries with new ones. 12 SPECIFICATIONS Minimum RMS Output Power per Channel (PURE DIRECT; ON) Maximum Input Signal (1 kHz, 0. 01% THD) Channel Separation (Vol. ­30 dB) ENGLISH <AX-570> PHONO MM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 mV PHONO MC. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 mV <AX-570> PHONO MM/MC (Input Shorted 1 kHz/10 kHz) . . . . . . . . . . . . . . . . . . . . . . . . . 75 dB/60 dB CD/TUNER/TAPE/AUX (Input 5. 1 k-ohms Terminated 1 kHz/10 kHz) . . . . . . 65 dB/50 dB <AX-570> 8 ohms, 20 Hz to 20 kHz, 0. 015% THD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100W+100W 6 ohms, 20 Hz to 20 kHz, 0. 03% THD [Except Scandinavia model] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120W+120W <AX-400> PHONO MM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 115 mV Output Level/Impedance <AX-400> <AX-570> REC OUT . . . . . . . . . . . . . . . . . . . . . . 150 mV/220 ohms PRE OUT. . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 0V/470 ohms CD/TUNER/TAPE/AUX (Input 5. 1 k-ohms Terminated 1 kHz/10 kHz) . . . . . . 65 dB/50 dB Tone Control Characteristics BASS: Boost/cut . . . . . . . . . . . . . . . . ±10 dB (20 Hz) TREBLE: Boost/cut. . . . . . . . . . . ±10 dB (20 kHz) Filter Characteristics <AX-570 only> SUBSONIC FILTER . . . . . . . . . 15 Hz, ­18 dB/oct Continuous Loudness Control Attenuation . . . . . . . . . . . . . . . . . . . . . . . . . . . . ­30 dB (1 kHz) (Level related equalization) Gain Tracking Error (0 to ­60 dB) <AX-400> 8 ohms, 20 Hz to 20 kHz, 0. 015% THD [Except Europe model] . . . . . . . . . . . . . . 65W+65W [Europe model] . . . . . . . . . . . . . . . . . . . . . . . . . . 75W+75W 6 ohms, 20 Hz to 20 kHz, 0. 03% THD [U. S. A. [. . . ]